Commit f2a4c59d authored by Murali Karicheri's avatar Murali Karicheri Committed by Kevin Hilman

DaVinci - Adding platform & board changes for vpfe capture on DM365

This patch adds following changes:-
	1) add sub device configuration data for TVP5146 used by vpfe capture
	2) registers platform devices for vpfe_capture, isif and vpss
	3) defines hardware resources for the devices listed under 2)
	4) defines clock aliase for isif driver
	5) adding setup_pinmux() for isif
Signed-off-by: default avatarMurali Karicheri <m-karicheri2@ti.com>
Signed-off-by: default avatarKevin Hilman <khilman@deeprootsystems.com>
parent abe94c75
......@@ -37,6 +37,8 @@
#include <mach/nand.h>
#include <mach/keyscan.h>
#include <media/tvp514x.h>
static inline int have_imager(void)
{
/* REVISIT when it's supported, trigger via Kconfig */
......@@ -306,6 +308,73 @@ static void dm365evm_mmc_configure(void)
davinci_cfg_reg(DM365_SD1_DATA0);
}
static struct tvp514x_platform_data tvp5146_pdata = {
.clk_polarity = 0,
.hs_polarity = 1,
.vs_polarity = 1
};
#define TVP514X_STD_ALL (V4L2_STD_NTSC | V4L2_STD_PAL)
/* Inputs available at the TVP5146 */
static struct v4l2_input tvp5146_inputs[] = {
{
.index = 0,
.name = "Composite",
.type = V4L2_INPUT_TYPE_CAMERA,
.std = TVP514X_STD_ALL,
},
{
.index = 1,
.name = "S-Video",
.type = V4L2_INPUT_TYPE_CAMERA,
.std = TVP514X_STD_ALL,
},
};
/*
* this is the route info for connecting each input to decoder
* ouput that goes to vpfe. There is a one to one correspondence
* with tvp5146_inputs
*/
static struct vpfe_route tvp5146_routes[] = {
{
.input = INPUT_CVBS_VI2B,
.output = OUTPUT_10BIT_422_EMBEDDED_SYNC,
},
{
.input = INPUT_SVIDEO_VI2C_VI1C,
.output = OUTPUT_10BIT_422_EMBEDDED_SYNC,
},
};
static struct vpfe_subdev_info vpfe_sub_devs[] = {
{
.name = "tvp5146",
.grp_id = 0,
.num_inputs = ARRAY_SIZE(tvp5146_inputs),
.inputs = tvp5146_inputs,
.routes = tvp5146_routes,
.can_route = 1,
.ccdc_if_params = {
.if_type = VPFE_BT656,
.hdpol = VPFE_PINPOL_POSITIVE,
.vdpol = VPFE_PINPOL_POSITIVE,
},
.board_info = {
I2C_BOARD_INFO("tvp5146", 0x5d),
.platform_data = &tvp5146_pdata,
},
},
};
static struct vpfe_config vpfe_cfg = {
.num_subdevs = ARRAY_SIZE(vpfe_sub_devs),
.sub_devs = vpfe_sub_devs,
.i2c_adapter_id = 1,
.card_name = "DM365 EVM",
.ccdc = "ISIF",
};
static void __init evm_init_i2c(void)
{
davinci_init_i2c(&i2c_pdata);
......@@ -497,6 +566,8 @@ static struct davinci_uart_config uart_config __initdata = {
static void __init dm365_evm_map_io(void)
{
/* setup input configuration for VPFE input devices */
dm365_set_vpfe_config(&vpfe_cfg);
dm365_init();
}
......
......@@ -1008,6 +1008,97 @@ void __init dm365_init(void)
davinci_common_init(&davinci_soc_info_dm365);
}
static struct resource dm365_vpss_resources[] = {
{
/* VPSS ISP5 Base address */
.name = "isp5",
.start = 0x01c70000,
.end = 0x01c70000 + 0xff,
.flags = IORESOURCE_MEM,
},
{
/* VPSS CLK Base address */
.name = "vpss",
.start = 0x01c70200,
.end = 0x01c70200 + 0xff,
.flags = IORESOURCE_MEM,
},
};
static struct platform_device dm365_vpss_device = {
.name = "vpss",
.id = -1,
.dev.platform_data = "dm365_vpss",
.num_resources = ARRAY_SIZE(dm365_vpss_resources),
.resource = dm365_vpss_resources,
};
static struct resource vpfe_resources[] = {
{
.start = IRQ_VDINT0,
.end = IRQ_VDINT0,
.flags = IORESOURCE_IRQ,
},
{
.start = IRQ_VDINT1,
.end = IRQ_VDINT1,
.flags = IORESOURCE_IRQ,
},
};
static u64 vpfe_capture_dma_mask = DMA_BIT_MASK(32);
static struct platform_device vpfe_capture_dev = {
.name = CAPTURE_DRV_NAME,
.id = -1,
.num_resources = ARRAY_SIZE(vpfe_resources),
.resource = vpfe_resources,
.dev = {
.dma_mask = &vpfe_capture_dma_mask,
.coherent_dma_mask = DMA_BIT_MASK(32),
},
};
static void dm365_isif_setup_pinmux(void)
{
davinci_cfg_reg(DM365_VIN_CAM_WEN);
davinci_cfg_reg(DM365_VIN_CAM_VD);
davinci_cfg_reg(DM365_VIN_CAM_HD);
davinci_cfg_reg(DM365_VIN_YIN4_7_EN);
davinci_cfg_reg(DM365_VIN_YIN0_3_EN);
}
static struct resource isif_resource[] = {
/* ISIF Base address */
{
.start = 0x01c71000,
.end = 0x01c71000 + 0x1ff,
.flags = IORESOURCE_MEM,
},
/* ISIF Linearization table 0 */
{
.start = 0x1C7C000,
.end = 0x1C7C000 + 0x2ff,
.flags = IORESOURCE_MEM,
},
/* ISIF Linearization table 1 */
{
.start = 0x1C7C400,
.end = 0x1C7C400 + 0x2ff,
.flags = IORESOURCE_MEM,
},
};
static struct platform_device dm365_isif_dev = {
.name = "isif",
.id = -1,
.num_resources = ARRAY_SIZE(isif_resource),
.resource = isif_resource,
.dev = {
.dma_mask = &vpfe_capture_dma_mask,
.coherent_dma_mask = DMA_BIT_MASK(32),
.platform_data = dm365_isif_setup_pinmux,
},
};
static int __init dm365_init_devices(void)
{
if (!cpu_is_davinci_dm365())
......@@ -1016,7 +1107,16 @@ static int __init dm365_init_devices(void)
davinci_cfg_reg(DM365_INT_EDMA_CC);
platform_device_register(&dm365_edma_device);
platform_device_register(&dm365_emac_device);
/* Add isif clock alias */
clk_add_alias("master", dm365_isif_dev.name, "vpss_master", NULL);
platform_device_register(&dm365_vpss_device);
platform_device_register(&dm365_isif_dev);
platform_device_register(&vpfe_capture_dev);
return 0;
}
postcore_initcall(dm365_init_devices);
void dm365_set_vpfe_config(struct vpfe_config *cfg)
{
vpfe_capture_dev.dev.platform_data = cfg;
}
......@@ -18,6 +18,7 @@
#include <mach/emac.h>
#include <mach/asp.h>
#include <mach/keyscan.h>
#include <media/davinci/vpfe_capture.h>
#define DM365_EMAC_BASE (0x01D07000)
#define DM365_EMAC_CNTRL_OFFSET (0x0000)
......@@ -36,4 +37,5 @@ void __init dm365_init_asp(struct snd_platform_data *pdata);
void __init dm365_init_ks(struct davinci_ks_platform_data *pdata);
void __init dm365_init_rtc(void);
void dm365_set_vpfe_config(struct vpfe_config *cfg);
#endif /* __ASM_ARCH_DM365_H */
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment