brcmsmac: remove ai_gpiocontrol()

This is now done by calling bcma_chipco_gpio_control().
Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
Tested-by: Arend van Spriel <arend@broadcom.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

drivers/net/wireless/brcm80211/brcmsmac/aiutils.c

@@ -856,15 +856,6 @@ int ai_pci_fixcfg(struct si_pub *sih)
 	return 0;
 }
 
-/* mask&set gpiocontrol bits */
-u32 ai_gpiocontrol(struct si_pub *sih, u32 mask, u32 val, u8 priority)
-{
-	uint regoff;
-
-	regoff = offsetof(struct chipcregs, gpiocontrol);
-	return ai_cc_reg(sih, regoff, mask, val);
-}
-
 /* Enable BT-COEX & Ex-PA for 4313 */
 void ai_epa_4313war(struct si_pub *sih)
 {

drivers/net/wireless/brcm80211/brcmsmac/aiutils.h

@@ -200,8 +200,6 @@ extern void ai_clkctl_init(struct si_pub *sih);
 extern u16 ai_clkctl_fast_pwrup_delay(struct si_pub *sih);
 extern bool ai_clkctl_cc(struct si_pub *sih, uint mode);
 extern bool ai_deviceremoved(struct si_pub *sih);
-extern u32 ai_gpiocontrol(struct si_pub *sih, u32 mask, u32 val,
-			     u8 priority);
 
 extern void ai_pci_down(struct si_pub *sih);
 extern void ai_pci_up(struct si_pub *sih);

drivers/net/wireless/brcm80211/brcmsmac/main.c

@@ -2208,7 +2208,7 @@ static void brcms_c_gpio_init(struct brcms_c_info *wlc)
 		gm |= gc |= BOARD_GPIO_PACTRL;
 
 	/* apply to gpiocontrol register */
-	ai_gpiocontrol(wlc_hw->sih, gm, gc, GPIO_DRV_PRIORITY);
+	bcma_chipco_gpio_control(&wlc_hw->d11core->bus->drv_cc, gm, gc);
 }
 
 static void brcms_ucode_write(struct brcms_hardware *wlc_hw,

drivers/net/wireless/brcm80211/brcmsmac/phy/phy_n.c

@@ -21343,7 +21343,7 @@ void wlc_phy_antsel_init(struct brcms_phy_pub *ppi, bool lut_init)
 		write_phy_reg(pi, 0xc8, 0x0);
 		write_phy_reg(pi, 0xc9, 0x0);
 
-		ai_gpiocontrol(pi->sh->sih, mask, mask, GPIO_DRV_PRIORITY);
+		bcma_chipco_gpio_control(&pi->d11core->bus->drv_cc, mask, mask);
 
 		mc = bcma_read32(pi->d11core, D11REGOFFS(maccontrol));
 		mc &= ~MCTL_GPOUT_SEL_MASK;