gpio: zynq: initialize clock even without CONFIG_PM

commit 0f84f29f upstream.

When the PM initialization was moved in the commit referenced below, the
code enabling the clock was removed from the probe function. On
CONFIG_PM=y kernels, this is not a problem as the pm resume hook enables
the clock, but when power management is disabled, all those pm_*
functions are noops and the clock is never enabled resulting in a
dysfunctional gpio controller.

Put the clock initialization back to support CONFIG_PM=n.
Signed-off-by: Helmut Grohne <h.grohne@intenta.de>
Fixes: 3773c195 ("gpio: zynq: Do PM initialization earlier to support gpio hogs")
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/gpio/gpio-zynq.c

@@ -709,7 +709,13 @@ static int zynq_gpio_probe(struct platform_device *pdev)
 		dev_err(&pdev->dev, "input clock not found.\n");
 		return PTR_ERR(gpio->clk);
 	}
+	ret = clk_prepare_enable(gpio->clk);
+	if (ret) {
+		dev_err(&pdev->dev, "Unable to enable clock.\n");
+		return ret;
+	}
 
+	pm_runtime_set_active(&pdev->dev);
 	pm_runtime_enable(&pdev->dev);
 	ret = pm_runtime_get_sync(&pdev->dev);
 	if (ret < 0)
@@ -747,6 +753,7 @@ static int zynq_gpio_probe(struct platform_device *pdev)
 	pm_runtime_put(&pdev->dev);
 err_pm_dis:
 	pm_runtime_disable(&pdev->dev);
+	clk_disable_unprepare(gpio->clk);
 
 	return ret;
 }