Commit fe45773b authored by Arik Nemtsov's avatar Arik Nemtsov Committed by Emmanuel Grumbach

iwlwifi: pcie: support loading FW with extended mem range

Toggle the LMPM_CHICK register when writing chunks into the FW's extended
SRAM. This tells the FW to put the chunk into a different memory space.
Signed-off-by: default avatarArik Nemtsov <arikx.nemtsov@intel.com>
Signed-off-by: default avatarEmmanuel Grumbach <emmanuel.grumbach@intel.com>
parent fb68e1a4
......@@ -368,4 +368,10 @@ enum secure_load_status_reg {
#define MON_BUFF_WRPTR (0xa03c44)
#define MON_BUFF_CYCLE_CNT (0xa03c48)
/* FW chicken bits */
#define LMPM_CHICK 0xA01FF8
enum {
LMPM_CHICK_EXTENDED_ADDR_SPACE = BIT(0),
};
#endif /* __iwl_prph_h__ */
......@@ -79,6 +79,10 @@
#include "iwl-fw-error-dump.h"
#include "internal.h"
/* extended range in FW SRAM */
#define IWL_FW_MEM_EXTENDED_START 0x40000
#define IWL_FW_MEM_EXTENDED_END 0x57FFF
static void iwl_pcie_free_fw_monitor(struct iwl_trans *trans)
{
struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
......@@ -627,14 +631,28 @@ static int iwl_pcie_load_section(struct iwl_trans *trans, u8 section_num,
}
for (offset = 0; offset < section->len; offset += chunk_sz) {
u32 copy_size;
u32 copy_size, dst_addr;
bool extended_addr = false;
copy_size = min_t(u32, chunk_sz, section->len - offset);
dst_addr = section->offset + offset;
if (dst_addr >= IWL_FW_MEM_EXTENDED_START &&
dst_addr <= IWL_FW_MEM_EXTENDED_END)
extended_addr = true;
if (extended_addr)
iwl_set_bits_prph(trans, LMPM_CHICK,
LMPM_CHICK_EXTENDED_ADDR_SPACE);
memcpy(v_addr, (u8 *)section->data + offset, copy_size);
ret = iwl_pcie_load_firmware_chunk(trans,
section->offset + offset,
p_addr, copy_size);
ret = iwl_pcie_load_firmware_chunk(trans, dst_addr, p_addr,
copy_size);
if (extended_addr)
iwl_clear_bits_prph(trans, LMPM_CHICK,
LMPM_CHICK_EXTENDED_ADDR_SPACE);
if (ret) {
IWL_ERR(trans,
"Could not load the [%d] uCode section\n",
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment