1. 03 Sep, 2014 35 commits
  2. 22 Aug, 2014 5 commits
    • Linus Torvalds's avatar
      Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net · 433ab34d
      Linus Torvalds authored
      Pull networking fixes from David Miller:
       "Here are some bug fixes that have piled up during ksummit/linuxcon.
      
         1) Fix endian problems in ibmveth, from Anton Blanchard.
      
         2) IPV6 routing code does GFP_KERNEL allocation in atomic, fix from
            Benjamin Block.
      
         3) SCTP association fixes from Daniel Borkmann.
      
         4) When multiple VLAN headers are present we have to make sure the
            second and subsequent ones are pullable in the SKB otherwise we
            blindly dereference garbage.  From Jiri Benc.
      
         5) The argument adjustment of the signature of hlist_add_after*()
            introduced a regression in the batman-adv code, fix from Sven
            Eckelmann.
      
         6) Fix TX hang handling to avoid a panic in i40e, from Anjali Singhai
            Jain.
      
         7) PTP flag test is inverted in i40e driver, from Jesse Brandeburg.
      
         8) ATM LEC driver needs to hold RTNL mutex over MTU changes, from
            Chas Williams.
      
         9) Truncate packets larger then the TPACKET_V3 format configured
            buffers, otherwise we overwrite past the end of said buffers.
            From Eric Dumazet.
      
        10) Fix endianness bugs in qlcnic firmware handling, from Rajesh
            Borundia and Shahed Shaikh.
      
        11) CXGB4 sometimes doesn't get all of the TX completion events it
            should resulting in SKBs getting stuck in the TX queue, from
            Hariprasad Shenai.
      
        12) When the FEC chip's PTP clock is disabled, you can't access the
            register.  Add necessary checks to avoid the resulting hang, from
            Fugang Duan"
      
      * git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (37 commits)
        drivers: isdn: eicon: xdi_msg.h: Fix typo in #ifndef
        net: sctp: fix suboptimal edge-case on non-active active/retrans path selection
        net: sctp: spare unnecessary comparison in sctp_trans_elect_best
        net: ethernet: broadcom: bnx2x: Remove redundant #ifdef
        ibmveth: Fix endian issues with rx_no_buffer statistic
        net: xgene: fix possible NULL dereference in xgene_enet_free_desc_rings()
        openvswitch: fix panic with multiple vlan headers
        net: ipv6: fib: don't sleep inside atomic lock
        net: fec: ptp: avoid register access when ipg clock is disabled
        cxgb4: Free completed tx skbs promptly
        cxgb4: Fix race condition in cleanup
        sctp: not send SCTP_PEER_ADDR_CHANGE notifications with failed probe
        bnx2x: Revert UNDI flushing mechanism
        qlcnic: Fix endianess issue in firmware load from file operation
        qlcnic: Fix endianess issue in FW dump template header
        qlcnic: Fix flash access interface to application
        MAINTAINERS: Add section for MRF24J40 IEEE 802.15.4 radio driver
        macvlan: Allow setting multicast filter on all macvlan types
        packet: handle too big packets for PACKET_V3
        MAINTAINERS: add entry for ec_bhf driver
        ...
      433ab34d
    • Rasmus Villemoes's avatar
      drivers: isdn: eicon: xdi_msg.h: Fix typo in #ifndef · faaa5524
      Rasmus Villemoes authored
      Test for definedness of the macro which is actually defined (the
      change is hard to see: it is s/SSS/SSA/).
      Signed-off-by: default avatarRasmus Villemoes <linux@rasmusvillemoes.dk>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      faaa5524
    • Daniel Borkmann's avatar
      net: sctp: fix suboptimal edge-case on non-active active/retrans path selection · aa4a83ee
      Daniel Borkmann authored
      In SCTP, selection of active (T.ACT) and retransmission (T.RET)
      transports is being done whenever transport control operations
      (UP, DOWN, PF, ...) are engaged through sctp_assoc_control_transport().
      
      Commits 4c47af4d ("net: sctp: rework multihoming retransmission
      path selection to rfc4960") and a7288c4d ("net: sctp: improve
      sctp_select_active_and_retran_path selection") have both improved
      it towards a more fine-grained and optimal path selection.
      
      Currently, the selection algorithm for T.ACT and T.RET is as follows:
      
      1) Elect the two most recently used ACTIVE transports T1, T2 for
         T.ACT, T.RET, where T.ACT<-T1 and T1 is most recently used
      2) In case primary path T.PRI not in {T1, T2} but ACTIVE, set
         T.ACT<-T.PRI and T.RET<-T1
      3) If only T1 is ACTIVE from the set, set T.ACT<-T1 and T.RET<-T1
      4) If none is ACTIVE, set T.ACT<-best(T.PRI, T.RET, T3) where
         T3 is the most recently used (if avail) in PF, set T.RET<-T.PRI
      
      Prior to above commits, 4) was simply a camp on T.ACT<-T.PRI and
      T.RET<-T.PRI, ignoring possible paths in PF. Camping on T.PRI is
      still slightly suboptimal as it can lead to the following scenario:
      
      Setup:
              <A>                                <B>
          T1: p1p1 (10.0.10.10) <==>  .'`)  <==> p1p1 (10.0.10.12)  <= T.PRI
          T2: p1p2 (10.0.10.20) <==> (_ . ) <==> p1p2 (10.0.10.22)
      
          net.sctp.rto_min = 1000
          net.sctp.path_max_retrans = 2
          net.sctp.pf_retrans = 0
          net.sctp.hb_interval = 1000
      
      T.PRI is permanently down, T2 is put briefly into PF state (e.g. due to
      link flapping). Here, the first time transmission is sent over PF path
      T2 as it's the only non-INACTIVE path, but the retransmitted data-chunks
      are sent over the INACTIVE path T1 (T.PRI), which is not good.
      
      After the patch, it's choosing better transports in both cases by
      modifying step 4):
      
      4) If none is ACTIVE, set T.ACT_new<-best(T.ACT_old, T3) where T3 is
         the most recently used (if avail) in PF, set T.RET<-T.ACT_new
      
      This will still select a best possible path in PF if available (which
      can also include T.PRI/T.RET), and set both T.ACT/T.RET to it.
      
      In case sctp_assoc_control_transport() *just* put T.ACT_old into INACTIVE
      as it transitioned from ACTIVE->PF->INACTIVE and stays in INACTIVE just
      for a very short while before going back ACTIVE, it will guarantee that
      this path will be reselected for T.ACT/T.RET since T3 (PF) is not
      available.
      
      Previously, this was not possible, as we would only select between T.PRI
      and T.RET, and a possible T3 would be NULL due to the fact that we have
      just transitioned T3 in sctp_assoc_control_transport() from PF->INACTIVE
      and would select a suboptimal path when T.PRI/T.RET have worse properties.
      
      In the case that T.ACT_old permanently went to INACTIVE during this
      transition and there's no PF path available, plus T.PRI and T.RET are
      INACTIVE as well, we would now camp on T.ACT_old, but if everything is
      being INACTIVE there's really not much we can do except hoping for a
      successful HB to bring one of the transports back up again and, thus
      cause a new selection through sctp_assoc_control_transport().
      
      Now both tests work fine:
      
      Case 1:
      
       1. T1 S(ACTIVE) T.ACT
          T2 S(ACTIVE) T.RET
      
       2. T1 S(ACTIVE) T.ACT, T.RET
          T2 S(PF)
      
       3. T1 S(ACTIVE) T.ACT, T.RET
          T2 S(INACTIVE)
      
       5. T1 S(PF) T.ACT, T.RET
          T2 S(INACTIVE)
      
      [ 5.1 T1 S(INACTIVE) T.ACT, T.RET
            T2 S(INACTIVE) ]
      
       6. T1 S(ACTIVE) T.ACT, T.RET
          T2 S(INACTIVE)
      
       7. T1 S(ACTIVE) T.ACT
          T2 S(ACTIVE) T.RET
      
      Case 2:
      
       1. T1 S(ACTIVE) T.ACT
          T2 S(ACTIVE) T.RET
      
       2. T1 S(PF)
          T2 S(ACTIVE) T.ACT, T.RET
      
       3. T1 S(INACTIVE)
          T2 S(ACTIVE) T.ACT, T.RET
      
       5. T1 S(INACTIVE)
          T2 S(PF) T.ACT, T.RET
      
      [ 5.1 T1 S(INACTIVE)
            T2 S(INACTIVE) T.ACT, T.RET ]
      
       6. T1 S(INACTIVE)
          T2 S(ACTIVE) T.ACT, T.RET
      
       7. T1 S(ACTIVE) T.ACT
          T2 S(ACTIVE) T.RET
      Signed-off-by: default avatarDaniel Borkmann <dborkman@redhat.com>
      Acked-by: default avatarNeil Horman <nhorman@tuxdriver.com>
      Acked-by: default avatarVlad Yasevich <vyasevich@gmail.com>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      aa4a83ee
    • Daniel Borkmann's avatar
      net: sctp: spare unnecessary comparison in sctp_trans_elect_best · ea4f19c1
      Daniel Borkmann authored
      When both transports are the same, we don't have to go down that
      road only to realize that we will return the very same transport.
      We are guaranteed that curr is always non-NULL. Therefore, just
      short-circuit this special case.
      Signed-off-by: default avatarDaniel Borkmann <dborkman@redhat.com>
      Acked-by: default avatarNeil Horman <nhorman@tuxdriver.com>
      Acked-by: default avatarVlad Yasevich <vyasevich@gmail.com>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      ea4f19c1
    • Rasmus Villemoes's avatar
      net: ethernet: broadcom: bnx2x: Remove redundant #ifdef · 7d149c52
      Rasmus Villemoes authored
      Nothing defines _ASM_GENERIC_INT_L64_H, it is a weird way to check for
      64 bit longs, and u64 should be printed using %llx anyway.
      Signed-off-by: default avatarRasmus Villemoes <linux@rasmusvillemoes.dk>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      7d149c52