While at it:
- idedisk_capacity() -> ide_disk_capacity()
- idedisk_proc[] -> ide_disk_proc[]
- idedisk_settings[] -> ide_disk_settings[]

v2/3:
Build fix for CONFIG_IDE_PROC_FS=n from Elias Oltmanns.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

While at it:
- idedisk_ioctl() -> ide_disk_ioctl()
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

While at it:
- idefloppy_capacity() -> ide_floppy_capacity()
- idefloppy_proc[] -> ide_floppy_proc[]
- idefloppy_settings[] -> ide_floppy_settings[]

v2:
Build fix for CONFIG_IDE_PROC_FS=n from Elias Oltmanns.

Cc: Borislav Petkov <petkovbb@gmail.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

While at it:
- idefloppy_ioctl() -> ide_floppy_ioctl()

v2:
Fix for idefloppy_ioctl name change from Stephen Rothwell.

Cc: Borislav Petkov <petkovbb@gmail.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Cc: Borislav Petkov <petkovbb@gmail.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Set IDE_AFLAG_DRQ_INTERRUPT in do_identify() instead of ATAPI
device drivers *_setup() methods.

While at it:
- use ata_id_cdb_intr()

There should be no functional changes caused by this patch.

Cc: Borislav Petkov <petkovbb@gmail.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

* Remove no longer used ide_host_alloc_all().

* Add MAX_HOST_PORTS define and use it instead of MAX_HWIFS
  as the maximum number of host ports possible.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

There is now a generic solution [ide_generic_check_pci_legacy_iobases()]
so MIPS-specific ide_probe_legacy() is no longer necessary.

Cc: Ralf Baechle <ralf@linux-mips.org>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

* Rename ->ide_dma_clear_irq method to ->clear_irq
  and move it from ide_hwif_t to struct ide_port_ops.

* Move ->waiting_for_dma check inside ->clear_irq method.

* Move ->dma_base check inside ->clear_irq method.

piix.c:
* Add ich_port_ops and remove init_hwif_ich() wrapper.

There should be no functional changes caused by this patch.
Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Noticed-by: Russell King <rmk+lkml@arm.linux.org.uk>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

* Add 'struct task_s' to ide_hwif_t and init it to the current command
  in do_rw_taskfile().

* Merge all TASKFILE_NO_DATA data phase handlers into taskfile_no_intr().
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Factor out reset error reporting from reset_pollfunc()
to ide_reset_report_error() helper.

While at it:
- fix KERN_* printk() levels
- remove 'switch ()'
Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

* Convert 'pio_mode' device setting to use DS_SYNC flag.

* Remove unused special_t.b.{set_tune,serviced} and ide_drive_t.tune_req.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

* Use 'drive->dn & 1' in ide_init_disk().

* remove [ata_]select_t.

While at it:

* Use ATA_DEVICE_OBS define in ide_port_init_devices_data().
Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

* Call ide_port_init_devices() in ide_host_register()
  also if 'struct ide_port_info *d' is not available.

* Init drive->dn in ide_port_init_devices() instead of
  ide_probe_port() so it is valid also in ->init_dev.

* Pass device number to ide_dev_apply_params().

* Use 'drive->dn & 1' instead of drive->select.b.unit.

There should be no functional changes caused by this patch.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Having CY82C693_DEBUG_INFO is enough nowadays.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Remove dead CY82C693_SETDMA_CLOCK code and now not needed
init_chipset_cy82c693().
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

* Move ide*_pm_* enums from ide-io.c to <linux/ide.h>.

* idedisk_pm_* -> ide_pm_*

* ide_pm_state_* -> ide_pm_*

* No need to set ide_pm_* enums to the fixed values.

* Uppercase ide_pm_* enums.

* Fix/update comments.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Add IDE_DFLAG_LBA device flag and use it instead of ->select.b.lba.

Since ->tf_load uses ->select.all for ATA Device/Head register this
fixes HDIO_DRIVE_TASK[FILE] ioctls for CHS commands on LBA devices.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Add IDE_DFLAG_DMA_PIO_RETRY and use it instead of
ide_drive_t.state + DMA_PIO_RETRY.

There should be no functional changes cause by this patch.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Add 'unsigned long dev_flags' to ide_drive_t and convert bitfields
to IDE_DFLAG_* flags.

While at it:
- IDE_DFLAG_ADDRESSING -> IDE_DFLAG_LBA48
- fixup some comments
- remove needless g->flags zeroing from ide*_probe()

There should be no functional changes caused by this patch.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Add ide_do_setfeature() helper and convert set_{wcache,acoustic}()
to use it.

There should be no functional changes caused by this patch.
Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

* Return -EIO if arg > 0 and LBA48 is unsupported.

* No need to reset ->addressing.

* Make ->addressing a single bit flag.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

ACPI _GTM / _PS0 / _STM were not called if only slave device was present.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

... with which to control to verbosity of debug messages on module load time.
Signed-off-by: Borislav Petkov <petkovbb@gmail.com>
[bart: no need to zero debug_mask + move module_param() closer debug_mask]
[bart: init drive->debug_mask in ide_floppy_probe() not in idefloppy_open()]
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Also:

- leave in the possibility for optimizing away all debugging macros
- add a PFX macro and prepend all printk calls with it for consistency
- change idefloppy_create_rw_cmd's 1st arg from idefloppy_floppy_t * to
ide_drive_t *.
- add a missing printk-level in idefloppy_init
- fix minor checkpatch warnings
Signed-off-by: Borislav Petkov <petkovbb@gmail.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Add __ide_debug_log() debugging macro which is controlled by drive->debug_mask.
The macro has to have the macro DRV_NAME defined in each driver before use.
Also, add different debugging levels depending on the functionality debugged.
Signed-off-by: Borislav Petkov <petkovbb@gmail.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Add a debugging on/off switch for controlling driver debugging
messages dynamically.
Signed-off-by: Borislav Petkov <petkovbb@gmail.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Introduce to_ide_drv() and ide_drv_g() macros and replace the respective
definitions of similar ones in each driver.

There should be no functionality change resulting from this patch.
Signed-off-by: Borislav Petkov <petkovbb@gmail.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

I don't know why this was there, but it was dead code.
Signed-off-by: Adrian Bunk <bunk@kernel.org>
Cc: chris@zankel.net
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

MAX_HWIFS is now always equal to the number of IDE major numbers.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Because hd.c was moved to drivers/block/ this config option
is superfluous now and may be removed.

v2:
Fix drivers/ide/Makefile (noticed by Adrian Bunk).

Cc: Adrian Bunk <bunk@kernel.org>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

* Move ->ticks field from struct ide_floppy_obj to ide_drive_t.

* Move idefloppy_transfer_pc() to ide-atapi.c and make
  ide_transfer_pc() use it.

* Always use ide_transfer_pc as a handler in ide_issue_pc().

* Remove no longer used idefloppy_start_pc_transfer(),
  ide*_transfer_pc() and 'handler' argument from ide_issue_pc().

* Make ide_transfer_pc() static.

While at it:

* idefloppy_transfer_pc() -> ide_delayed_transfer_pc()

* IDEFLOPPY_TICKS_DELAY -> IDEFLOPPY_PC_DELAY

* ->ticks -> ->pc_delay

There should be no functional changes caused by this patch.

Cc: Borislav Petkov <petkovbb@gmail.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

* Always use ide_pc_intr as a handler in ide_pc_intr().

* Remove no longer used ide*_pc_intr() and 'handler'
  argument from ide_{transfer_pc,pc_intr}().

* Make ide_pc_intr() static.

There should be no functional changes caused by this patch.

Cc: Borislav Petkov <petkovbb@gmail.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Add ->pc_{update,io}_buffers methods to ide_drive_t and use
them instead of {update,io}_buffers ide_pc_intr() arguments.

There should be no functional changes caused by this patch.

Cc: Borislav Petkov <petkovbb@gmail.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

* Add ide_create_request_sense_cmd() and ide_retry_pc() helpers
  and convert ide-{atapi,floppy,tape}.c to use them.

* Remove no longer used ide*_create_request_sense_cmd(),
  ide*_retry_pc() and 'retry_pc' argument from ide_pc_intr().

* Make ide_queue_pc_head() static.

There should be no functional changes caused by this patch.

Cc: Borislav Petkov <petkovbb@gmail.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>