* Bug fix: Not able to set autoneg on using ethtool when interface
  down, Not able to change speed/duplex using ethtool/mii when interface
  up, Ethtool shows autoneg on when forced to 100/Full

Contributed by Scott Feldman @ Intel

Contributed by Scott Feldman @ Intel

Contributed by Scott Feldman @ Intel

* Update change log
* Whitespace cleanup
* Bug fix: protect against zero-length skb in hard_start
* Bug fix: validate MAC address using is_valid_ether_addr()

Contributed by Scott Feldman @ Intel

Contributed by Scott Feldman @ Intel.

* Get WOL settings from EEPROM
* Remove PHY WOL support as device downshofts from 1GbE to 10/100 during
  suspend, which causes a PHY event, which causes the system to wake up!
  The downshifting to 10/100 is to reduce power.

Contributed by Scott Feldman @ Intel

Contributed by Richard Henderson

Contributed by Jonathan Shapiro

Found by Ion Badulescu.

Use ".init.plt" section consistently, and mark plt sections executable.

This brings pci.ids in your BK tree in sync with my database.

I've merged changes from both 2.4 and 2.5 with direct submissions to my
repository and deleted a few entries which are obviously wrong.

"savesegment()" is declared in multiple places. Clean up and declare
it just once in <asm/system.h>

into home.transmeta.com:/home/torvalds/v2.5/linux

The attached patch fixes the crash top or cat /proc/*/wchan produces
when using KALLSYMS it's a buffer overrun that should not happen.

Based on patch by andi kleen.

into home.transmeta.com:/home/torvalds/v2.5/linux

into samba.org:/scratch/anton/for-alan

into samba.org:/scratch/anton/for-alan