Commits · 498879417756effe6dc385ee04645a83d724fdef · nexedi / linux

09 Jan, 2006 40 commits

[PATCH] PCI: use bus numbers sparsely, if necessary · 49887941

Dominik Brodowski authored Dec 08, 2005

Add a warning if a child bus may be inaccessible because the
parent bridge has wrong secondary or subordinate bus numbers.
Note that this may or may not happen on "transparent" bridges,
as can be seen in bug #5557.

Also, if we do not fix up the assignment of bus numbers, try to
make use of the bus number space available.
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

49887941

[PATCH] pciehp: allow bridged card hotplug · 0eb3bcfd

Rajesh Shah authored Dec 08, 2005

This patch fixes bugs in the pciehp driver that prevent hot-add
of a card with PCI bridges on it.
Signed-off-by: Rajesh Shah <rajesh.shah@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

0eb3bcfd

[PATCH] pciehp: handle sticky power-fault status · c7ab337f

Thomas Schaefer authored Dec 08, 2005

This patch disables power fault, MRL sensor and presence detection
interrupts when a PCIe slot is powered-off and enables those
interrupts when it is powered-on again. This is necessary to prevent
the associated events from causing an endless cycle of interrupts
due to the power-fault bit, which stays set till power is restored
to the slot.
Signed-off-by: Thomas Schaefer <thomas.schaefer@kontron.com>
Signed-off-by: Rajesh Shah <rajesh.shah@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

c7ab337f

[PATCH] PCI Quirk: 1K I/O space granularity on Intel P64H2 · 9d265124

Daniel Yeisley authored Dec 05, 2005

I've implemented a quirk to take advantage of the 1KB I/O space
granularity option on the Intel P64H2 PCI Bridge. I had to change
probe.c because it sets the resource start and end to be aligned on 4k
boundaries (after the quirk sets them to 1k boundaries). I've tested
this patch on a Unisys ES7000-600 both with and without the 1KB option
enabled. I also tested this on a 2 processor Dell box that doesn't have
a P64H2 to make sure there were no negative affects there.
Signed-off-by: Dan Yeisley <dan.yeisley@unisys.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

9d265124

[PATCH] shpchp: Implement get_address callback · 81f15442

Kenji Kaneshige authored Dec 05, 2005

The following patch implements .get_address callback of
hotplug_slot_ops for SHPCHP driver. With this patch, we
can see bus address of hotplug slots as follows:

	$ cat address
	0000:0b:01
Signed-off-by: Kenji Kaneshige <kaneshige.kenji@jp.fujitsu.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

81f15442

[PATCH] PCI Hotplug/powerpc: more removal of duplicated code · cd5b50be

linas@austin.ibm.com authored Dec 01, 2005

The RPAPHP code contains two routines that appear to be gratuitous copies
of very similar pci code.  In particular,

   rpaphp_claim_resource ~~ pci_claim_resource
      (there is a minor, non-functional difference)

   rpadlpar_claim_one_bus == pcibios_claim_one_bus
      (the code is identical)

This patch removes the rpaphp versions of the code.
Signed-off-by: Linas Vepstas <linas@austin.ibm.com>
Acked-by: John Rose <johnrose@austin.ibm.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

cd5b50be

[PATCH] PCI Hotplug/powerpc: remove duplicated code · d681db4a

linas@austin.ibm.com authored Dec 01, 2005

The RPAPHP code contains a routine that duplicates some existing code.
This patch removes the rpaphp version of the code.
Signed-off-by: Linas Vepstas <linas@austin.ibm.com>
Acked-by: John Rose <johnrose@austin.ibm.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

d681db4a

[PATCH] PCI: irq.c: trivial printk and DBG updates · 81745512

Daniel Marjamäki authored Dec 01, 2005

Updated printk and DBG with appropriate KERN_*.
Signed-off-by: Daniel Marjamki <daniel.marjamaki@comhem.se>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

81745512

[PATCH] shpchp: fix improper wait for command completion · bd62e271

Kenji Kaneshige authored Nov 25, 2005

Current SHPCHP driver uses msleep_interruptible() function to wait for
a command completion event. But I think this would cause an unnecessary
long wait until timeout, if command completion interrupt came before
task state was changed to TASK_INTERRUPTIBLE. This patch fixes this
issue. With this patch, command completion becomes faster as follows:

o Without this patch

	# time echo 1 > power

	real    0m4.708s
	user    0m0.000s
	sys     0m0.524s

o With this patch

	# time echo 1 > power

	real    0m2.221s
	user    0m0.000s
	sys     0m0.532s
Signed-off-by: Kenji Kaneshige <kaneshige.kenji@jp.fujitsu.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

bd62e271

[PATCH] shpchp: fix improper write to Command Completion Detect bit · f467f618

Kenji Kaneshige authored Nov 24, 2005

Current SHPCHP driver writes a '0' to the Command Completion Detect
bit to clear the Command Complete Interrupt Pending. But according to
the SHPC spec (See 4.7.3.1 System Interrupts), SHPCHP driver must
write '1'. This patch fixes this bug.
Signed-off-by: Kenji Kaneshige <kaneshige.kenji@jp.fujitsu.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

f467f618

[PATCH] shpchp: fix improper mmio mapping · 0455986c

Kenji Kaneshige authored Nov 24, 2005

Current SHPCHP driver seems not to map MMIO region properly. This
patch fixes this bug. This patch also cleanup the code.
Signed-off-by: Kenji Kaneshige <kaneshige.kenji@jp.fujitsu.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

0455986c

[PATCH] shpchp: fix improper reference to Mode 1 ECC Capability" bit · 87d6c559

Kenji Kaneshige authored Nov 24, 2005

The hpc_get_mode1_ECC_cap() function of SHPCHP driver seems to refer
the wrong bit for refering the "Mode 1 ECC Capability" bit. This bug
seems not to cause any problem so far. But I think this should be
fixed. This patch fixes this bug.
Signed-off-by: Kenji Kaneshige <kaneshige.kenji@jp.fujitsu.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

87d6c559

[PATCH] shpchp: fix improper reference to Slot Avail Regsister · 6558b6ab

Kenji Kaneshige authored Nov 24, 2005

The hpc_get_max_bus_speed() function of the SHPCHP driver seems to
refer wrong bits in the "Slot Avail Register I" and "Slot Avail
Register II". This patch fixes this bug. And this also cleanup the
code.
Signed-off-by: Kenji Kaneshige <kaneshige.kenji@jp.fujitsu.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

6558b6ab

[PATCH] shpchp: replace pci_find_slot() with pci_get_slot() · e00e57ef

Kenji Kaneshige authored Nov 25, 2005

This patch replaces pci_find_slot() with pci_get_slot() in the SHPCHP
driver. This enables SHPCHP driver to work on multiple PCI segment
systems.
Signed-off-by: Kenji Kaneshige <kaneshige.kenji@jp.fujitsu.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

e00e57ef

[PATCH] PCI Hotplug: cpqphp_ctrl.c: remove dead code · 2555f7bd

Adrian Bunk authored Nov 21, 2005

The Coverity checker spotted that we already did return -ENOMEM
if (!p_mem_node).
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

2555f7bd

[PATCH] PCI Hotplug: ibmphp_pci.c copy-n-paste fix · 88d69a1d

Jordan, William P authored Nov 21, 2005

I noticed what appears to be a cut/paste error in
drivers/pci/hotplug/ibmphp_pci.c:
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

88d69a1d

[PATCH] PCIE: make bus_id for PCI Express devices unique · 8c9ad508

Sergey Vlasov authored Nov 14, 2005

The bus_id string must be unique for all devices of that bus in the
system, not just for devices with the same parent - otherwise multiple
symlinks with identical names appear in /sys/bus/pci_express/devices.
Signed-off-by: Sergey Vlasov <vsu@altlinux.ru>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

8c9ad508

[PATCH] PCI: arch/i386/pci/acpi.c: use for_each_pci_dev · fb37fb96

Hanna Linder authored Nov 06, 2005

Signed-off-by: Hanna Linder <hannal@us.ibm.com>
Signed-off-by: Maximilian Attems <janitor@sternwelten.at>
Signed-off-by: Domen Puncer <domen@coderock.org>
Signed-off-by: Alexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>