- 12 Oct, 2007 32 commits
-
-
Matthew Wilcox authored
At some point during Linux 2.1 development, ioremap() gained the ability to handle addresses which weren't page-aligned. Also expand the CONFIG_PCI range to encompass that entire section of wide board initialisation, since all wide boards are PCI. Signed-off-by:
Matthew Wilcox <matthew@wil.cx> Signed-off-by:
James Bottomley <James.Bottomley@SteelEye.com>
-
Matthew Wilcox authored
By moving a test from AscGetChipBusType into its only caller, we can delete the whole function Signed-off-by:
-
Matthew Wilcox authored
Remove some useless forward declarations Reformat some comments, debug messages, and the occasional piece of real code Removal of unnecessary braces Remove duplicate setting of shost->irq Signed-off-by:
-
Matthew Wilcox authored
Use slave_configure() to do all the work that used to be done in AscInquiryHandling and AdvInquiryHandling. Split slave_configure into two functions, one for wide and one for narrow controllers. Remove some unused definitions, duplicate definitions, unnecessary declarations, and scsireqq, cap_info and inquiry from struct asc_board. Signed-off-by:
-
Matthew Wilcox authored
According to the AdvanSys driver, this device has a problem with tagged queueing. Signed-off-by:
-
Matthew Wilcox authored
AscCompareString() is just another name for strncmp Signed-off-by:
-
Matthew Wilcox authored
- Remove wrappers around the PCI configuration space accessors - Call pci_set_master() instead of poking at config space directly - Move the latency setting into one function called for both narrow and wide boards. - Tidy up AdvInitGetConfig() a little. - Delete a few unused prototypes and definitions. Signed-off-by:
-
Matthew Wilcox authored
Make sure the resources are reserved and released by all the callers of advansys_board_found(). This eliminates the check_region-style race. It also allows us to use the pci_request_regions() API. Signed-off-by:
-
Matthew Wilcox authored
Register two isa_drivers, one for ISA and one for VLB, in order to preserve detection order. When deleting advansys_detect, we lose the last vestiges of the code that limited IO port scanning. This code has been effectively disabled for many years anyway; I'll restore it in a module_param later. We also lose the code that placed all ISA PnP cards into WaitForKey state -- drivers shouldn't be doing this anyway. The asc_host array goes away too. Also remove some IOADR and other definitions, such as ASC_NUM_BOARD_SUPPORTED. Signed-off-by:
-
Matthew Wilcox authored
- Switch EISA probing to the driver model - Remove some now-unused macros and functions - Update the FIXME now that we use the correct driver model probing API Signed-off-by:
-
Matthew Wilcox authored
- Add a pci_driver interface for the PCI advansys devices (for ISA/EISA/VLB devices, we still call advansys_detect). - Many functions are converted from __init to __devinit to allow hotplug PCI to work. - Only keep devices found by advansys_detect in the asc_host list. - Rename asc_board_count to asc_legacy_count. New asc_board_count is only used to generate a unique name for each device. - Remove some now-unused macros and struct definitions Signed-off-by:
-
Matthew Wilcox authored
- Switch from scsi_register/scsi_unregister to scsi_host_alloc, scsi_add_host, scsi_scan_host and scsi_host_put. - Rename the scsi_host_template to advansys_template - Use module_init and module_exit instead of scsi_module.c - Remove protection against advansys_detect being called twice Signed-off-by:
-
Matthew Wilcox authored
- Put all the error cleanup at the end of the function and goto the appropriate label - Split advansys_wide_init_chip out of advansys_board_found - Split advansys_wide_free_mem out of advansys_board_found. Use it from advansys_release - Use GFP_KERNEL, not GFP_ATOMIC, when allocating memory during initialisation - Eliminate lots of PROC_FS ifdefs by removing the ifdefs around the prtbuf struct member Signed-off-by:
-
Matthew Wilcox authored
The interrupt routines used to walk the list of Scsi_Hosts belonging to this driver to make sure that the scsi_cmnd belonged to one of them. This is a waste of time and gets in the way of later cleanups, so delete it. Signed-off-by:
-
Matthew Wilcox authored
Pass the Scsi_Host to the interrupt handler, rather than polling all hosts for each interrupt. Return IRQ_NONE if we didn't handle this interrupt Don't set the IRQF_DISABLED flag; this is not a fast-executing interrupt handler. Signed-off-by:
-
Matthew Wilcox authored
Just use the Scsi_Host passed in, rather than looking through the driver's own array of boards for one that matches it. Signed-off-by:
-
Matthew Wilcox authored
Update the version to 3.4 Add my copyright Add myself to MAINTAINERS Exercise my right to change the license from dual BSD/GPL to GPL Don't force the definition of CONFIG_ISA on x86 Always include pci.h Stop including stat.h Signed-off-by:
-
FUJITA Tomonori authored
unsigned short is too small for sizeof(struct scatterlist) * min(q->max_hw_segments, q->max_phys_segments). This fixes memory leak with 4096 segments since 16 (likely sg size with x86) * 4096 sets sglist_len to zero. This might not happen without sg chaining support. Signed-off-by:
FUJITA Tomonori <fujita.tomonori@lab.ntt.co.jp> Acked-by:
Douglas Gilbert <dougg@torque.net> Signed-off-by:
-
Matthew Wilcox authored
Stress-testing and some thought has revealed some places where asynchronous scanning needs some more attention to locking. - Since async_scan is a bit, we need to hold the host_lock while modifying it to prevent races against other CPUs modifying the word that bit is in. This is probably a theoretical race for the moment, but other patches may change that. - The async_scan bit means not only that this host is being scanned asynchronously, but that all the devices attached to this host are not yet added to sysfs. So we must ensure that this bit is always in sync. I've chosen to do this with the scan_mutex since it's already acquired in most of the right places. - If the host changes state to deleted while we're in the middle of a scan, we'll end up with some devices on the host's list which must be deleted. Add a check to scsi_sysfs_add_devices() to ensure the host is still running. - To avoid the async_scan bit being protected by three locks, the async_scan_lock now only protects the scanning_list. Signed-off-by:
-
Boaz Harrosh authored
- use scsi_cmnd data accessors - Clean the !use_sg code paths Signed-off-by:
Boaz Harrosh <bharrosh@panasas.com> Acked-by:
Greg Kroah-Hartman <gregkh@suse.de> [jejb: merge conflict fix] Signed-off-by:
-
Mike Christie authored
sg's may have setup a the buffer with a different length than the transfer length so we should be using the bufflen passed in as the request's data len. Signed-off-by:
Mike Christie <michaelc@cs.wisc.edu> Signed-off-by:
-
FUJITA Tomonori authored
This converts ps3rom driver to use the new accessors for the sg lists and the parameters. Signed-off-by:
Geert Uytterhoeven <Geert.Uytterhoeven@sonycom.com> Signed-off-by:
-
FUJITA Tomonori authored
it's better to remove tgt dependencies in srp transport class since most people want only initiator support. Signed-off-by:
-
FUJITA Tomonori authored
This converts ibmvstgt to use transport tsk_mgmt_response callback. Signed-off-by:
-
FUJITA Tomonori authored
This moves tsk_mgmt_response callback in struct scsi_host_template to struct scsi_transport_template since struct scsi_transport_template is more suitable for the task management stuff. Signed-off-by:
-
FUJITA Tomonori authored
This converts libsrp and ibmvstgt to use srp transport. Signed-off-by:
Brian King <brking@us.ibm.com> Signed-off-by:
-
FUJITA Tomonori authored
This adds minimum target driver support: - srp_rport_{add,del} calls scsi_tgt_it_nexus_{create,destroy} for target drivers. - add a callback to notify target drivers of the nexus operation results to srp_function_template. Signed-off-by: -
FUJITA Tomonori authored
tgt uses scsi_host as I_T nexus. This works for ibmvstgt because it creates one scsi_host for one initiator. However, other target drivers don't work like that. This adds I_T nexus support, which enable one scsi_host to handle multiple initiators. New scsi_tgt_it_nexus_create/destroy functions are expected be called transport classes. For example, ibmvstgt creates an initiator remote port, then the srp transport calls tgt_it_nexus_create. tgt doesn't manages I_T nexus, instead it tells tgtd, user-space daemon, to create a new I_T nexus. On the receiving the response from tgtd, tgt calls shost->transportt->it_nexus_response. transports should notify a lld. The srp transport uses it_nexus_response callback in srp_function_template to do that. Signed-off-by:
-
FUJITA Tomonori authored
This adds a 'roles' attribute to rport like transport_fc. The role can be initiator or target. That is, the initiator driver creates target remote ports and the target driver creates initiator remote ports. Signed-off-by:
-
FUJITA Tomonori authored
This converts ib_srp to use the srp transport class. I don't have ib hardware so I've not tested this patch. Signed-off-by:
-
FUJITA Tomonori authored
This converts ibmvscsi to use the srp transport class. Signed-off-by:
-
FUJITA Tomonori authored
This adds srp transport class that works with ib_srp and ibmvscsi. It creates only /sys/class/{srp_host,srp_remote_ports} and srp_remote_ports has only "port_id" attribute. viola:/sys/class/srp_remote_ports/port-0:1# ls device port_id subsystem uevent viola:/sys/class/srp_remote_ports/port-0:1# cat port_id 4c:49:4e:55:58:20:56:49:4f:00:00:00:00:00:00:00 Signed-off-by:
-
- 15 Aug, 2007 8 commits
-
-
Andrew Vasquez authored
Signed-off-by:
Andrew Vasquez <andrew.vasquez@qlogic.com> Signed-off-by:
-
Andrew Vasquez authored
Signed-off-by:
-
Andrew Vasquez authored
Original implementation manipulated the FC_GS values for port-speed. Transition the codes to use the driver's own internal representations as this makes for a reduction in duplicate 'conversion' codes throughout the driver. Signed-off-by:
-
Andrew Vasquez authored
Transitioning link-state via NOS/OLS requires a relogin to a fabric's Management Server. Request relogin when the firmware issues a point-to-point asynchronous event (0x8030). Signed-off-by:
-
Andrew Vasquez authored
Signed-off-by:
-
Andrew Vasquez authored
Signed-off-by:
-
Heiko Carstens authored
Fix the data buffer accessor patch. For request without a data buffer nothing was written into a SBALE. Signed-off-by:
Heiko Carstens <heiko.carstens@de.ibm.com> Signed-off-by:
Swen Schillig <swen@vnet.ibm.com> Signed-off-by:
-
Heiko Carstens authored
allocate gid_pn_data objects from gid_pn_cache. Allocate gid_pn_data objects from the corresponding cache which ensures proper alignment. Signed-off-by:
Martin Schwidefsky <schwidefsky@de.ibm.com> Signed-off-by:
-
