xscale-type UARTs have an extra bit (UUE) in the IER register that has
to be written as 1 to enable the UART.  At the end of autoconfig() in
drivers/serial/8250.c, the IER register is unconditionally written as
zero, which turns off the UART, and makes any subsequent printch() hang
the box.

Since other 8250-type UARTs don't have this enable bit and are thus
always 'enabled' in this sense, it can't hurt to enable xscale-type
serial ports all the time as well.  The attached patch changes the
autoconfig() exit path to see if the port has an UUE enable bit, and if
yes, to write UUE=1 instead of just putting a zero into IER, using the
same test as is used at the beginning of serial8250_console_write().
Signed-off-by: Lennert Buytenhek <buytenh@wantstofly.org>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

As per the new release rules: two weeks of merging, and then an -rc1 and
calming down for the next release.

Also introduces a sysctl option to configure the receive buffer
accounting policy to be either at socket or association level.
Default is all the associations on the same socket share the
receive buffer.
Signed-off-by: Neil Horman <nhorman@tuxdriver.com>
Signed-off-by: Sridhar Samudrala <sri@us.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

On ia64, it is possible to get NaT Consumption Fault and a kernel panic
when initializing sctp sideeffect commands arguments.  The union
sctp_arg_t contains different sized elements and when loading a smaller
sized element (32 or 16 bits), it is possible for a speculative load to
fail and result in a NaT bit set which causes a kernel crash.  The easy
way to get around it is to load the largerst member of the union.
Signed-off-by: Vladislav Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: Sridhar Samudrala <sri@us.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

The socket level timeout values are maintained in sctp_sock and
association level timeouts are in sctp_association. So there is
no need for ep->timeouts.
Signed-off-by: Vladislav Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: Sridhar Samudrala <sri@us.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

It is possible to get to sctp_v4_get_saddr() without a valid
association.  This happens when processing OOTB packets and
the cached route entry is no longer valid.
However, when responding to OOTB packets we already properly
set the source address based on the information in the OOTB
packet.  So, if we we get to sctp_v4_get_saddr() without an
association we can simply return.
Signed-off-by: Vladislav Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: Sridhar Samudrala <sri@us.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Based mostly upon a patch from Olaf Kirch <okir@suse.de>

When initialization fails in inet6_init(), we should
unregister the PF_INET6 socket ops.

Also, check sock_register()'s return value for errors.
Signed-off-by: David S. Miller <davem@davemloft.net>

scsi_wait_req does not exist any more in the SCSI layer.  This patch
makes it so libata can compile again.
Signed-off-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

After the last merge of the new unified 'powerpc' architecture, ppc64 no
longer compiles cleanly as a standalone architecture.  Some bits and
pieces still exist as files under the old ppc64 hierarchy, but the old
"ARCH=ppc64" is dead.

So if "uname" says ppc64, that now implies that the default architecture
should be "powerpc".
Acked-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Lennert Buytenhek

Update the ixp2000 defconfigs to 2.6.14-git13.
Signed-off-by: Lennert Buytenhek <buytenh@wantstofly.org>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Nicolas Pitre

For assembly labels to actually be local they must start with ".L" and
not only "." otherwise they still remain visible in the final link and
clutter kallsyms needlessly, and possibly make for unclear symbolic
backtrace. This patch simply inserts a"L" where appropriate. The code
itself is unchanged.
Signed-off-by: Nicolas Pitre <nico@cam.org>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Nicolas Pitre

For assembly labels to actually be local they must start with ".L" and
not only "." otherwise they still remain visible in the final link and
clutter kallsyms needlessly, and possibly make for unclear symbolic
backtrace. This patch simply inserts a"L" where appropriate. The code
itself is unchanged.
Signed-off-by: Nicolas Pitre <nico@cam.org>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Nicolas Pitre

For assembly labels to actually be local they must start with ".L" and
not only "." otherwise they still remain visible in the final link and
clutter kallsyms needlessly, and possibly make for unclear symbolic
backtrace. This patch simply inserts a"L" where appropriate. The code
itself is unchanged.
Signed-off-by: Nicolas Pitre <nico@cam.org>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Noticed by Tom 'spot' Callaway.

Even on uniprocessor we always reported the number of physical
cpus in the system via /proc/cpuinfo.  But when this got changed
to use num_possible_cpus() it always reads as "1" on uniprocessor.
This change was unintentional.

So scan the firmware device tree and count the number of cpu
nodes, and report that, as we always did.
Signed-off-by: David S. Miller <davem@davemloft.net>

Currently recvmsg generates SIGPIPE whereas sendmsg does not; for the
other stacks it seems to be the other way round!

It also fixes the bug where reading from a socket whose peer has shutdown
returned -EINVAL rather than 0.
Signed-off-by: Patrick Caulfield <patrick@tykepenguin.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Fix default VGA console on SN platforms.  Since SN firmware does not pass
enough ACPI information to identify VGA cards and the associated legacy IO/MEM
addresses, we rely on the EFI PCDP table.  Since the linux pcdp driver is
optional (and overridden if console= directives are used) SN duplicates a
portion of the pcdp scan code to identify if there is a usable console VGA
adapter.  Additionally, dup necessary pcdp related structs to avoid dragging
drivers/pcdp.h into a more public location.
Signed-off-by: Mark Maule <maule@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>

This patch introduces 4-level page tables to ia64.  I have run
some benchmarks and found nothing interesting.  Performance has
consistently fallen within the noise range.

It also introduces a config option (setting the default to 3
levels).  The config option prevents having 4 level page
tables with 64k base page size.
Signed-off-by: Robin Holt <holt@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>

Part of a patch was accidentally reverted, this corrects an
inconsistent spinlock use in the IPMI message handler.
Signed-off-by: Hironobu Ishii <hishii@soft.fujitsu.com>
Signed-off-by: Corey Minyard <minyard@acm.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Recent TCP changes broke the build.
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

As part of the ISO C9x conversion gcc deprecates concatenation with
__FUNCTION__ because __FUNCTION__ is not a preprocessor macro.
Signed-off-by: Clemens Buchacher <drizzd@aon.at>
Signed-off-by: Maximilian Attems <janitor@sternwelten.at>
Signed-off-by: Domen Puncer <domen@coderock.org>
Signed-off-by: Alexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

The following patch support the SMC9111 present on DB1200 boards.
Signed-off-by: Nicolas Pitre <nico@cam.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

 o Try to work around some of the undocumented "features" of the SAA9730
 o Use netdev_priv() instead of the previous broken mechanism to allocate
   the private data structure.
 o Try to make sure we don't leak resources on exit.
 o No more need to call SET_MODULE_OWNER in 2.6.
 o Use pci_free_consistent instead of homegrown architecture-specific
   allocation.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

 drivers/net/saa9730.c |  531 +++++++++++++++++++++++---------------------------
 1 files changed, 249 insertions(+), 282 deletions(-)
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

Kill trailing whitespace, replace leading whitespace with tabs.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

 drivers/net/saa9730.c |   98 +++++++++++++++++++++++++-------------------------
 1 files changed, 49 insertions(+), 49 deletions(-)
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

Added phy address 0 to the phy scan.
Signed-off-by: Ayaz Abdulla <aabdulla@nvidia.com>

This patch contains support for different modes of interrupt mitigation
of forcedeth. It includes changes based on Jeff's comments. Currently,
the modes are changed through module parameters since ethtool does not
support something similar.
Signed-off-by: Ayaz Abdulla <aabdulla@nvidia.com>

Signed-off-by: Ayaz Abdulla <aabdulla@nvidia.com>

To ensure that phy_mask and any future elements of the mii_bus
structure are initialized use kzalloc() instead of kmalloc().

This fixes an issue in which phy_mask was not being initialized
and we would skip random phy addresses when scanning.
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>