- 15 Dec, 2011 37 commits
-
-
nagalakshmi.nandigama@lsi.com authored
Signed-off-by:
Nagalakshmi Nandigama <nagalakshmi.nandigama@lsi.com> Signed-off-by:
James Bottomley <JBottomley@Parallels.com>
-
nagalakshmi.nandigama@lsi.com authored
[SCSI] mpt2sas: Rearrange the the code so that the completion queues are initialized prior to sending the request to controller firmware Signed-off-by:
-
nagalakshmi.nandigama@lsi.com authored
[SCSI] mpt2sas: Do not set sas_device->starget to NULL from the slave_destroy callback when all the LUNS have been deleted If the sas_device->starget to NULL from slave_destroy callback for LUN=1 even though LUN=0 exist, results in entire target getting deleted. To resolve the issue, the driver should only set sas_device->starget to NULL when all the LUNS have been deleted from the slave_destroy. Signed-off-by:
-
nagalakshmi.nandigama@lsi.com authored
1) Added product specific range of ImageType macros for the Extended Image Header. 2) Added Flags field and related defines to MPI2_TOOLBOX_ISTWI_READ_WRITE_REQUEST to support automatic reserve/release and page addressing. Signed-off-by:
-
nagalakshmi.nandigama@lsi.com authored
Signed-off-by:
-
nagalakshmi.nandigama@lsi.com authored
[SCSI] mpt2sas: When IOs are terminated, update the result to DID_SOFT_ERROR to avoid infinite resets Signed-off-by:
-
nagalakshmi.nandigama@lsi.com authored
Detection of Dead IOC has been done in fault_reset_work thread. If IOC Doorbell is 0xFFFFFFFF, it will be detected as non-operation/DEAD IOC. When a DEAD IOC is detected, the code is modified to remove that IOC and all its attached devices from OS. The PCI layer API pci_remove_bus_device() is called to remove the dead IOC. Signed-off-by:
-
Dan Carpenter authored
"sense_len" was declared as int type but actually it only stores a u16 value that comes from hardware. The cast to u16 in min_t() confuses static analysis because it truncates the int to u16 so I've fixed the declaration to reflect that "sense_len" is just a u16. Also there was a call to cpu_to_be16() which I've changed to be16_to_cpu(). The functions are equivalent, but obviously the hardware is big endian and we're doing the min_t() comparison on CPU endian values. This whole patch is just a cleanup and doesn't affect how the code works. Signed-off-by:
Dan Carpenter <dan.carpenter@oracle.com> Reviewed-by:
Mike Christie <michaelc@cs.wisc.edu> Acked-by:
Jayamohan Kallickal <Jayamohan.kallickal@emulex.com> Signed-off-by:
-
Tomas Henzl authored
The '5i' controller freezes when a kdump is attemted. This patch admits it and adds the controller to the unresetable list. Signed-off-by:
Tomas Henzl <thenzl@redhat.com> Signed-off-by:
-
Stephen M. Cameron authored
IRQF_SHARED is required for older controllers that don't support MSI(X) and which may end up sharing an interrupt. All the controllers hpsa normally supports have MSI(X) capability, but older controllers may be encountered via the hpsa_allow_any=1 module parameter. Also remove deprecated IRQF_DISABLED. Signed-off-by:
Stephen M. Cameron <scameron@beardog.cce.hp.com> Signed-off-by:
-
Chandrakala Chavva authored
Signed-off-by:
Chandrakala Chavva <cchavva@caviumnetworks.com> Signed-off-by:
David Daney <david.daney@cavium.com> Acked-by:
-
Ferenc Wagner authored
Using strlcpy instead of memcpy makes the strlen() calls superfluous and also ensures zero-termination of the copied string. At the same time get rid of the magic constant 50. Actually, I can't see why copying the callback name is necessary instead of simply storing a pointer to it (just like to the callback function itself), but that goes beyond the scope of this fix. Signed-off-by:
Ferenc Wagner <wferi@niif.hu> Acked-by:
-
Jesper Juhl authored
One ';' at the end of the return statement is enough. Signed-off-by:
Jesper Juhl <jj@chaosbits.net> Acked-by:
Chad Dupuis <chad.dupuis@qlogic.com> Signed-off-by:
-
Chad Dupuis authored
Signed-off-by:
-
Chad Dupuis authored
Some variables need to be initialized before we config PCI I/O config space or else strange firmware initialization errors may occur. Signed-off-by:
-
Andrew Vasquez authored
The driver should ensure there's a sufficient number of IOCBs to satisfy the number of scatter-gather entries specified in the command. Add a 'count' to the control structure, srb_ctx, to use in qla2x00_alloc_iocbs(). Signed-off-by:
Andrew Vasquez <andrew.vasquez@qlogic.com> Signed-off-by:
-
Saurav Kashyap authored
This provides a capability to set a priority in the FCP packet. Signed-off-by:
Saurav Kashyap <saurav.kashyap@qlogic.com> Signed-off-by:
-
Giridhar Malavali authored
Signed-off-by:
Giridhar Malavali <giridhar.malavali@qlogic.com> Signed-off-by:
-
Giridhar Malavali authored
When multiple request queues are created process the marker IOCB request on request queue 0. Signed-off-by:
-
Giridhar Malavali authored
Add a new function to ISP specific pointers structure to take care of ISP specific PCI IO space configuration. Signed-off-by:
-
Giridhar Malavali authored
Signed-off-by:
-
Giridhar Malavali authored
Signed-off-by:
Chad Dupuis <chad.dupuis@qlogic> Signed-off-by:
-
Joe Carnuccio authored
Correct the erroneous return codes introduced by the following patch: "Return sysfs error codes appropriate to conditions". Signed-off-by:
Joe Carnuccio <joe.carnuccio@qlogic.com> Signed-off-by:
-
Giridhar Malavali authored
Signed-off-by:
-
Giridhar Malavali authored
Signed-off-by:
-
Andrew Vasquez authored
The 'continue' cases neglected to place the thread in an interruptible state, causing the DPC routine to wake immediately. Signed-off-by:
-
Andrew Vasquez authored
When reading the incoming mailbox registers, read only the specified ones. Signed-off-by:
-
Giridhar Malavali authored
[jejb: fixed up checkpatch and casting errors] Signed-off-by:
-
Chad Dupuis authored
This patch contains minor fixes to our new logging infrastructure: - Remove extranous messages. - Re-add 'nexus' and 'hdl' information. - Adjusted the message ids to fill up the holes. - Display FCP_CMND priority on update. - Log only mail box error conditions. - Do not print "Firmware ready **** FAILED ****" if cable is unplugged. - Drop noisy 'fw_state...curr time...' message. - Correct nexus display during abort. - Add a special case error-logging set to '1'. - Catagorize I/O exception display handling. - Correct the bsg msg code printing. - Dont use dynamic logging after host is removed. Signed-off-by:
-
Joe Perches authored
[SCSI] qla2xxx: Make the logging functions verify their arguments and fixed the current broken uses as appropriate. Signed-off-by:
Joe Perches <joe@perches.com> Signed-off-by:
-
Joe Perches authored
Return early when logging level too low. Use normal kernel codeing style for function braces. Add const where appropriate to logging functions. Remove now unused #define QL_DBG_BUF_LEN. Signed-off-by:
-
Jing Huang authored
Fix some endian issue. __BIGENDIAN is not defined and it needs to be replaced with __BIG_ENDIAN. Also fixed a bug in bit field access. These two issues were reported by Dan Carpenter. Signed-off-by:
Jing Huang <huangj@brocade.com> Signed-off-by:
-
Jing Huang authored
Fixed code indentation and alignment issues. Fixed all checkpatch warnings. Signed-off-by:
-
Moger, Babu authored
All the handlers have now implemented the match function so We don't need to use scsi_dev_info any more for matching purposes. Signed-off-by:
Babu Moger <babu.moger@netapp.com> Acked-by:
Hannes Reinecke <hare@suse.de> Signed-off-by:
-
Moger, Babu authored
This patch introduces the match function for rdac device handler. Without this, sometimes handler attach fails during the device_add. Included check for TPGS bit before proceeding further. The match function was introduced by commit 6c3633d0Signed-off-by:
-
Moger, Babu authored
This patch introduces the match function for hp_sw device handler. Included the check for TPGS bit before proceeding further per Hannes comment. The match function was introduced by commit 6c3633d0Signed-off-by:
-
Moger, Babu authored
This patch introduces the match function for emc device handler. Included check for TPGS bit before proceeding further. The match function was introduced by commit 6c3633d0Signed-off-by:
-
- 14 Dec, 2011 3 commits
-
-
Eddie Wai authored
During session recovery, the conn_stop call will trigger a flush to all outstanding SCSI cmds in the xmit queue. This will set all outstanding task->sc to NULL prior to the session_teardown call which frees the task memory. In the bnx2i SCSI response processing path, only the task was being checked for NULL under the session lock before the task->sc->request dereferencing. If there are outstanding SCSI cmd responses pending for process, the following kernel panic can be exposed where task->sc was found to be NULL. Call Trace: [ 69.720205] [<ffffffffa040d0d0>] bnx2i_process_new_cqes+0x290/0x3c0 [bnx2i] [ 69.804289] [<ffffffffa040d233>] bnx2i_fastpath_notification+0x33/0xa0 [bnx2 i] [ 69.891490] [<ffffffffa040d37b>] bnx2i_indicate_kcqe+0xdb/0x330 [bnx2i] [ 69.971427] [<ffffffffa03eac5e>] service_kcqes+0x16e/0x1d0 [cnic] [ 70.045132] [<ffffffffa03eacea>] cnic_service_bnx2x_kcq+0x2a/0x50 [cnic] [ 70.126105] [<ffffffffa03ead53>] cnic_service_bnx2x_bh+0x43/0x140 [cnic] [ 70.207081] [<ffffffff81060676>] tasklet_action+0x66/0x110 [ 70.273521] [<ffffffff8106025f>] __do_softirq+0xef/0x220 [ 70.337887] [<ffffffff81447ebc>] call_softirq+0x1c/0x30 This patch adds the !task->sc check and also protects the sc dereferencing under the session lock. Signed-off-by:
Eddie Wai <eddie.wai@broadcom.com> Signed-off-by:
-
Mike Christie authored
iscsi_conn_setup can fail so we must check for NULL being returned. Signed-off-by:
-
Tomas Henzl authored
When the qla4xxx_get_fwddb_entry returns QLA_ERROR the nex_idx is not updated, for (idx = 0; idx < max_ddbs; idx = next_idx) { ret = qla4xxx_get_fwddb_entry(ha, idx, NULL, 0, NULL, &next_idx, &state, &conn_err, NULL, NULL); if (ret == QLA_ERROR) continue; This means there is a risk that the 'idx < max_ddbs' condition will never met and the loop will loop forever. Fix this by explicitly increasing the next_idx in the error condition. Maybe a break instead of continue is more appropriate, leaving the decision on the qlogic maintainer. Signed-off-by:
-
