Up until now we were doing segment mappings wrong on Book3s_32. For Book3s_64
we were using a trick where we know that a single mmu_context gives us 16 bits
of context ids.

The mm system on Book3s_32 instead uses a clever algorithm to distribute VSIDs
across the available range, so a context id really only gives us 16 available
VSIDs.

To keep at least a few guest processes in the SID shadow, let's map a number of
contexts that we can use as VSID pool. This makes the code be actually correct
and shouldn't hurt performance too much.
Signed-off-by: Alexander Graf <agraf@suse.de>

There are some heuristics in the PPC power management code that try to find
out if the particular hardware we're running on supports proper power management
or just hangs the machine when going into nap mode.

Since we know that KVM is safe with nap, let's force enable it in the PV code
once we're certain that we are on a KVM VM.
Signed-off-by: Alexander Graf <agraf@suse.de>

We had an arbitrary limitation in mtmsrd L=1 that kept us from using r30 and
r31 as input registers. Let's get rid of that and get more potential speedups!
Signed-off-by: Alexander Graf <agraf@suse.de>

When having a decrementor interrupt pending, the dequeuing happens manually
through an mtdec instruction. This instruction simply calls dequeue on that
interrupt, so the int_pending hint doesn't get updated.

This patch enables updating the int_pending hint also on dequeue, thus
correctly enabling guests to stay in guest contexts more often.
Signed-off-by: Alexander Graf <agraf@suse.de>

So far we've been restricting ourselves to r0-r29 as registers an mtmsr
instruction could use. This was bad, as there are some code paths in
Linux actually using r30.

So let's instead handle all registers gracefully and get rid of that
stupid limitation
Signed-off-by: Alexander Graf <agraf@suse.de>

This is the guest side of the mtsr acceleration. Using this a guest can now
call mtsrin with almost no overhead as long as it ensures that it only uses
it with (MSR_IR|MSR_DR) == 0. Linux does that, so we're good.
Signed-off-by: Alexander Graf <agraf@suse.de>

Now that the actual mtsr doesn't do anything anymore, we can move the sr
contents over to the shared page, so a guest can directly read and write
its sr contents from guest context.
Signed-off-by: Alexander Graf <agraf@suse.de>

Right now we're examining the contents of Book3s_32's segment registers when
the register is written and put the interpreted contents into a struct.

There are two reasons this is bad. For starters, the struct has worse real-time
performance, as it occupies more ram. But the more important part is that with
segment registers being interpreted from their raw values, we can put them in
the shared page, allowing guests to mess with them directly.

This patch makes the internal representation of SRs be u32s.
Signed-off-by: Alexander Graf <agraf@suse.de>

The current approach duplicates the spr->bat finding logic and makes it harder
to reuse the actually used variables. So let's move everything down to the spr
handler.
Signed-off-by: Alexander Graf <agraf@suse.de>

We will soon add SR PV support to the shared page, so we need some
infrastructure that allows the guest to query for features KVM exports.

This patch adds a second return value to the magic mapping that
indicated to the guest which features are available.
Signed-off-by: Alexander Graf <agraf@suse.de>

The define VSID_ALL is unused. Let's remove it.
Signed-off-by: Alexander Graf <agraf@suse.de>

It turns out the in-kernel hash function is sub-optimal for our subtle
hash inputs where every bit is significant. So let's revert to the original
hash functions.

This reverts commit 05340ab4f9a6626f7a2e8f9fe5397c61d494f445.
Signed-off-by: Alexander Graf <agraf@suse.de>

This patch moves debugging printks for shadow SLB debugging over to tracepoints.
Signed-off-by: Alexander Graf <agraf@suse.de>

There is a race condition in the pte invalidation code path where we can't
be sure if a pte was invalidated already. So let's move the spin lock around
to get rid of the race.
Signed-off-by: Alexander Graf <agraf@suse.de>

When hitting a no-execute or read-only data/inst storage interrupt we were
flushing the respective PTE so we're sure it gets properly overwritten next.

According to the spec, this is unnecessary though. The guest issues a tlbie
anyways, so we're safe to just keep the PTE around and have it manually removed
from the guest, saving us a flush.
Signed-off-by: Alexander Graf <agraf@suse.de>

When the guest jumps into kernel mode and has the magic page mapped, theres a
very high chance that it will also use it. So let's detect that scenario and
map the segment accordingly.
Signed-off-by: Alexander Graf <agraf@suse.de>

The different ways of flusing shadow ptes have their own debug prints which use
stupid old printk.

Let's move them to tracepoints, making them easier available, faster and
possible to activate on demand
Signed-off-by: Alexander Graf <agraf@suse.de>

After a flush the sid map contained lots of entries with 0 for their gvsid and
hvsid value. Unfortunately, 0 can be a real value the guest searches for when
looking up a vsid so it would incorrectly find the host's 0 hvsid mapping which
doesn't belong to our sid space.

So let's also check for the valid bit that indicated that the sid we're
looking at actually contains useful data.
Signed-off-by: Alexander Graf <agraf@suse.de>

This patch moves the SPTE flush debug printk over to tracepoints.
Signed-off-by: Alexander Graf <agraf@suse.de>

This patch moves the generic mmu map debugging over to tracepoints.
Signed-off-by: Alexander Graf <agraf@suse.de>

This patch moves Book3s MMU debugging over to tracepoints.
Signed-off-by: Alexander Graf <agraf@suse.de>

We have a debug printk on every exit that is usually #ifdef'ed out. Using
tracepoints makes a lot more sense here though, as they can be dynamically
enabled.

This patch converts the most commonly used debug printks of EXIT_DEBUG to
tracepoints.
Signed-off-by: Alexander Graf <agraf@suse.de>

The following patch

  commit 57ce1659316f4ca298919649f9b1b55862ac3826
  KVM: x86: In DM_LOWEST, only deliver interrupts to vcpus with enabled LAPIC's

ignored the fact that kvm_irq_delivery_to_apic() was also used by ia64.

We define kvm_lapic_enabled() to fix a compile error caused by this.
This will have the same effect as reverting the problematic patch for ia64.
Signed-off-by: Takuya Yoshikawa <yoshikawa.takuya@oss.ntt.co.jp>
Signed-off-by: Avi Kivity <avi@redhat.com>

The audit is very high overhead, so we need lower the frequency to assure
the guest is running.
Signed-off-by: Xiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Signed-off-by: Avi Kivity <avi@redhat.com>

Both audit_mappings() and audit_sptes_have_rmaps() need to walk vcpu's page
table, so we can do these checking in a spte walking
Signed-off-by: Xiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Signed-off-by: Avi Kivity <avi@redhat.com>

Both audit_rmap() and audit_write_protection() need to walk all active sp, so
we can do these checking in a sp walking
Signed-off-by: Xiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Signed-off-by: Avi Kivity <avi@redhat.com>

Move the audit code from arch/x86/kvm/mmu.c to arch/x86/kvm/mmu_audit.c
Signed-off-by: Xiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Signed-off-by: Avi Kivity <avi@redhat.com>

Add a r/w module parameter named 'mmu_audit', it can control audit
enable/disable:

enable:
  echo 1 > /sys/module/kvm/parameters/mmu_audit

disable:
  echo 0 > /sys/module/kvm/parameters/mmu_audit

This patch not change the logic
Signed-off-by: Xiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Signed-off-by: Avi Kivity <avi@redhat.com>

MSR_K7_CLK_CTL is a no longer documented MSR, which is only relevant
on said old AMD CPU models. This change returns the expected value,
which the Linux kernel is expecting to avoid writing back the MSR,
plus it ignores all writes to the MSR.
Signed-off-by: Jes Sorensen <Jes.Sorensen@redhat.com>
Signed-off-by: Avi Kivity <avi@redhat.com>

ICW is not a full reset, instead it resets a limited number of registers
in the PIC.  Change ICW1 emulation to only reset those registers.
Signed-off-by: Avi Kivity <avi@redhat.com>

x86_emulate_insn() is full of things like

    if (rc != X86EMUL_CONTINUE)
        goto done;
    break;

consolidate all of those at the end of the switch statement.
Signed-off-by: Avi Kivity <avi@redhat.com>

These are all undefined.
Signed-off-by: Avi Kivity <avi@redhat.com>

Signed-off-by: Avi Kivity <avi@redhat.com>

It is read/only; restoring it only results in annoying messages.
Signed-off-by: Avi Kivity <avi@redhat.com>

Otherwise EFER_LMA bit is retained across a SIPI reset.

Fixes guest cpu onlining.
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Signed-off-by: Avi Kivity <avi@redhat.com>

Since commit aad82703 no mmu reinitialization is performed
via init_vmcb.

Zero vcpu->arch.cr0 and pass the reset value as a parameter to
kvm_set_cr0.
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Signed-off-by: Avi Kivity <avi@redhat.com>

out = write, in = read, not the other way round.
Signed-off-by: Avi Kivity <avi@redhat.com>

Nothing is checked in count_rmaps(), so remove it
Signed-off-by: Xiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Signed-off-by: Avi Kivity <avi@redhat.com>

There is a bugs in this function, we call gfn_to_pfn() and kvm_mmu_gva_to_gpa_read() in
atomic context(kvm_mmu_audit() is called under the spinlock(mmu_lock)'s protection).

This patch fix it by:
- introduce gfn_to_pfn_atomic instead of gfn_to_pfn
- get the mapping gfn from kvm_mmu_page_get_gfn()

And it adds 'notrap' ptes check in unsync/direct sps
Signed-off-by: Xiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Signed-off-by: Avi Kivity <avi@redhat.com>

The audit code reports some sp not write protected in current code, it's just the
bug in audit_write_protection(), since:

- the invalid sp not need write protected
- using uninitialize local variable('gfn')
- call kvm_mmu_audit() out of mmu_lock's protection
Signed-off-by: Xiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Signed-off-by: Avi Kivity <avi@redhat.com>