Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Used for vce power management.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Required for dpm on CI.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Needed for DPM on CI.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Uses a different table format if the board supports EVV.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

This added support for the on-chip thermal sensors on
CIK asics.

v2: fix register offset.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

No support for reading temperature back yet.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Used for uvd power management.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Internally we switched to using a separate header for
atombios pplib definitions.  Switch over the open source
driver.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Needed for DPM on KB/KV.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Only the APUs support power gating.

v2: disable cgcg for now
v3: workaround hw issue in mgcg
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

and remove duplicate si_rlc functions.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

This will eventually be shared with newer asics to
reduce code duplication.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Restructure rlc setup to handle clock and power
gating.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Enables PCIE ASPM (Active State Power Management) on
CIK asics.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Required for DPM on CIK.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Calculate the low and high watermarks based on the low and high
clocks for the current power state.  The dynamic pm hw will select
the appropriate watermark based on the internal dpm state.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Newer asics don't have specific UVD states.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Newer asics have a lot of vram so it's less of an
issue to waste a little more space for the gart
page table.  This gives us some additional gart space
before having to migrate to non-gart system ram
for games, etc. where we use up most of vram.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

1. Handle the the thermal state directly in the work handler.
Remove the state selection function since nothing else uses it now.
2. On some asics there is no thermal state, so we just use a regular
state and force the low performance state.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Use the UVD handle information to determine which
which power states to select when using UVD.  For
example, decoding a single SD stream requires much
lower clocks than multiple HD streams.

v2: switch to a cleaner dpm/uvd interface
v3: change the uvd power state while streams
are active if need be
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Add a helper function for counting the number of open stream handles.

v2: fix copy-pasta in comments and whitespace error
v3: make function static since it's only used in radeon_uvd.c
at the moment
v4: make non-static again for future changes
v5: make static again for new rework of dpm uvd changes
Signed-off-by: Christian König <christian.koenig@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

No longer used now that we use the async dma engines or
CP DMA for bo copies.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

CP DMA is lighter weight than using the 3D engine.
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

This LCD monitor (1280x1024 native) has a completely
bogus detailed timing (640x350@70hz).  User reports that
1280x1024@60 has waves so prefer 1280x1024@75.

Manufacturer: MED  Model: 7b8  Serial#: 99188
Year: 2005  Week: 5
EDID Version: 1.3
Analog Display Input,  Input Voltage Level: 0.700/0.700 V
Sync:  Separate
Max Image Size [cm]: horiz.: 34  vert.: 27
Gamma: 2.50
DPMS capabilities: Off; RGB/Color Display
First detailed timing is preferred mode
redX: 0.645 redY: 0.348   greenX: 0.280 greenY: 0.605
blueX: 0.142 blueY: 0.071   whiteX: 0.313 whiteY: 0.329
Supported established timings:
720x400@70Hz
640x480@60Hz
640x480@72Hz
640x480@75Hz
800x600@56Hz
800x600@60Hz
800x600@72Hz
800x600@75Hz
1024x768@60Hz
1024x768@70Hz
1024x768@75Hz
1280x1024@75Hz
Manufacturer's mask: 0
Supported standard timings:
Supported detailed timing:
clock: 25.2 MHz   Image Size:  337 x 270 mm
h_active: 640  h_sync: 688  h_sync_end 784 h_blank_end 800 h_border: 0
v_active: 350  v_sync: 350  v_sync_end 352 v_blanking: 449 v_border: 0
Monitor name: MD30217PG
Ranges: V min: 56 V max: 76 Hz, H min: 30 H max: 83 kHz, PixClock max 145 MHz
Serial No: 501099188
EDID (in hex):
          00ffffffffffff0034a4b80774830100
          050f010368221b962a0c55a559479b24
          125054afcf00310a0101010101018180
          000000000000d60980a0205e63103060
          0200510e1100001e000000fc004d4433
          3032313750470a202020000000fd0038
          4c1e530e000a202020202020000000ff
          003530313039393138380a2020200078
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Reported-by: friedrich@mailstation.de
Cc: stable@vger.kernel.org

This fixes the piglit test texturing/max-texture-size
causing the VM to die due to a too large SVGA command.
Signed-off-by: Jakob Bornecrantz <jakob@vmware.com>
Reviewed-by: Biran Paul <brianp@vmware.com>
Reviewed-by: Zack Rusin <zackr@vmware.com>
Cc: stable@vger.kernel.org
Signed-off-by: Dave Airlie <airlied@gmail.com>

Merge tag 'drm-intel-fixes-2013-08-30' of git://people.freedesktop.org/~danvet/drm-intel into drm-fixes

Just a one-line patch to fix a black screen issue on rare ivb machines,
cc: stable. Normally I'd just shovel this into the -next pull request this
late in the -rc cycle, but Linus was making noises about not getting real
fixes which are cc: stable. So here we go ;-)

* tag 'drm-intel-fixes-2013-08-30' of git://people.freedesktop.org/~danvet/drm-intel:
  drm/i915: ivb: fix edp voltage swing reg val

Fix the typo introduced in

commit 1a2eb460
Author: Keith Packard <keithp@keithp.com>
Date:   Wed Nov 16 16:26:07 2011 -0800

    drm/i915: Hook up Ivybridge eDP

This fixes eDP link-training failures and cases where all voltage swing
/pre-emphasis levels were tried and failed during clock recovery and -
as a fallback - we go on to do channel equalization with the last voltage
swing/pre-emphasis level which will succeed. Both issues can lead to a
blank screen.

v2:
- improve commit message

CC: stable@vger.kernel.org
Bugzilla: https://bugs.freedesktop.org/show_bug.cgi?id=64880Tested-by: Jeremy Moles <cubicool@gmail.com>
Signed-off-by: Imre Deak <imre.deak@intel.com>
Reviewed-by: Paulo Zanoni <paulo.r.zanoni@intel.com>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>

Pull staging fixes from Greg KH:
 "Here are two tiny staging tree fixes (well, one is for an iio driver,
  but those updates come through the staging tree due to dependancies)

  One fixes a problem with an IIO driver, and the other fixes a bug in
  the comedi driver core"

* tag 'staging-3.11-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/staging:
  staging: comedi: bug-fix NULL pointer dereference on failed attach
  iio: adjd_s311: Fix non-scan mode data read

Pull USB fixes from Greg KH:
 "Here are two USB fixes for 3.11-rc7

  One fixes a reported regression in the OHCI driver, and the other
  fixes a reported build breakage in the USB phy drivers"

* tag 'usb-3.11-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/usb:
  usb: phy: fix build breakage
  USB: OHCI: add missing PCI PM callbacks to ohci-pci.c

Pull ARM fixes from Russell King:
 "This round of fixes is smaller than previous: a couple more updates
  for the security fixes, and a one-liner kexec fix"

* 'fixes' of git://git.linaro.org/people/rmk/linux-arm:
  ARM: 7816/1: CONFIG_KUSER_HELPERS: fix help text
  ARM: 7815/1: kexec: offline non panic CPUs on Kdump panic
  ARM: 7819/1: fiq: Cast the first argument of flush_icache_range()

Pull vfs fixes from Al Viro:
 "Assorted fixes from the last week or so"

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/viro/vfs:
  VFS: collect_mounts() should return an ERR_PTR
  bfs: iget_locked() doesn't return an ERR_PTR
  efs: iget_locked() doesn't return an ERR_PTR()
  proc: kill the extra proc_readfd_common()->dir_emit_dots()
  cope with potentially long ->d_dname() output for shmem/hugetlb