- 01 Jun, 2010 5 commits
-
-
Dave Airlie authored
* drm-switcheroo-fixes: drm/kms: disable/enable poll around switcheroo on/off drm/nouveau: fixup confusion over which handle the DSM is hanging off. drm/nouveau: attempt to get bios from ACPI v3
-
Dave Airlie authored
* drm-vmware-fixes: drm/vmwgfx: Remove some leftover debug messages. drm/vmwgfx: Print warnings in kernel log about bo pinning that fails. drm/vmwgfx: Unpause overlay on update. drm/vmwgfx: Some modesetting cleanups and fixes. drm/vmwgfx: Don't use SVGA_REG_ENABLE in modesetting code. drm/vmwgfx: Remove duplicate member from struct vmw_legacy_display_unit. drm/vmwgfx: Reserve first part of VRAM for framebuffer. drm/vmwgfx: Support older hardware. drm/vmwgfx: Get connector status from detection function. drm/vmwgfx: Add kernel throttling support. Bump minor. drm/vmwgfx: Make sure to unpin old and pin new framebuffer. drm/vmwgfx: Fix single framebuffer detection. drm/vmwgfx: Assume larger framebuffer max size.
-
Dave Airlie authored
Because we aren't in a suspend state the poll will still run when we have switcherooed a card off. Signed-off-by:Dave Airlie <airlied@redhat.com>
-
Dave Airlie authored
This fixes the DSM setup correctly since vga switcheroo. Signed-off-by: -
Dave Airlie authored
Some of the laptops with the switchable graphics, seem to not post the secondary GPU at all, and we can't find a copy of the BIOS anywhere except in the ACPI rom retrieval. This adds support for ACPI ROM retrieval to nouveau. Signed-off-by:
-
- 31 May, 2010 15 commits
-
-
Thomas Hellstrom authored
Fix a number of typos misspellings and checkpatch.pl warnings. Replace "[ttm] " with TTM_PFX Signed-off-by:
Thomas Hellstrom <thellstrom@vmware.com> Signed-off-by:
-
Thomas Hellstrom authored
This patch fixes a regression introduced with the pool page allocator in the event that there are no highmem pages (for example x86_64), in which case cached page allocation would fail. Tested with the vmwgfx driver on a 64-bit vm. Signed-off-by:
-
Thomas Hellstrom authored
Signed-off-by:
-
Jakob Bornecrantz authored
Signed-off-by:
Jakob Bornecrantz <jakob@vmware.com> Signed-off-by:
-
Jakob Bornecrantz authored
The unpause codepath uses vmw_overlay_update() so we must unset the paused status. Signed-off-by:
-
Jakob Bornecrantz authored
Signed-off-by:
-
Jakob Bornecrantz authored
We should not use SVGA_REG_ENABLE anywhere but in the fifo setup code, since it controls whether the device is active. Signed-off-by:
-
Jakob Bornecrantz authored
Signed-off-by:
-
Thomas Hellstrom authored
The host may be touching this part of VRAM at modesetting, even if we never use it ourselves, since we blit screen updates from 3D surfaces. Make sure no DMA buffers are placed in this part of VRAM. V2: Fix an error check in vmw_surface_dmabuf_pin(). Signed-off-by:
-
Jakob Bornecrantz authored
V2: Fix a couple of typos. Signed-off-by:
-
Jakob Bornecrantz authored
Also make sure the ldu::active member is properly initialized. Part of fix by Michel Daenzer <daenzer@vmware.com>. Signed-off-by:
Michel Daenzer <daenzer@vmware.com> Signed-off-by:
-
Thomas Hellstrom authored
The throttle_us member in the execbuf argument is now honored. If the member is 0, no waiting for lag will occur, which guarantees backwards compatibility with well-behaved clients. Signed-off-by:
-
Jakob Bornecrantz authored
Signed-off-by:
-
Jakob Bornecrantz authored
V2: Fix a typo. Signed-off-by:
-
Jakob Bornecrantz authored
Signed-off-by:
-
- 28 May, 2010 1 commit
-
-
Dave Airlie authored
airlied -> brown paper bag. I blame Hi-5 or the Wiggles for lowering my IQ, move the fix inside some brackets instead of breaking everything in site. Cc: stable@kernel.org Signed-off-by:
-
- 26 May, 2010 3 commits
-
-
Jiri Slaby authored
Stanse found pci reference leaks in uli_agp_init and nforce3_agp_init initialization functions. The PCI devices are bridges, so it's not critical, but still worth fixing. Signed-off-by:
Jiri Slaby <jirislaby@gmail.com> Cc: Jesse Barnes <jbarnes@virtuousgeek.org> Signed-off-by:
Andrew Morton <akpm@linux-foundation.org> Signed-off-by:
-
Adam Jackson authored
Switches will try to update the topology address and not correctly fix up the checksum, so just let it slide. https://bugs.freedesktop.org/28229Signed-off-by:
Adam Jackson <ajax@redhat.com> Signed-off-by:
-
Stefan Richter authored
At least 'make CONFIG_DEBUG_SECTION_MISMATCH=y' causes drivers/gpu/drm/radeon/atombios_crtc.c: In function 'atombios_crtc_set_pll': drivers/gpu/drm/radeon/atombios_crtc.c:684: warning: 'pll' may be used uninitialized in this function which has the looks of a falso positive. Add a default: case so that gcc rests assured that all possible pll_id's are covered. Keep the present cases that fall through to the default one for self-documentation. Signed-off-by:
Stefan Richter <stefanr@s5r6.in-berlin.de> Reviewed-by:
Alex Deucher <alexdeucher@gmail.com> Signed-off-by:
-
- 24 May, 2010 3 commits
-
-
Prarit Bhargava authored
drivers/gpu/drm/nouveau/nv40_graph.c: In function `nv40_graph_init': drivers/gpu/drm/nouveau/nv40_graph.c:400: warning: the frame size of 1184 bytes is larger than 1024 bytes drivers/gpu/drm/radeon/radeon_atombios.c: In function `radeon_get_atom_connector_info_from_supported_devices_table': drivers/gpu/drm/radeon/radeon_atombios.c:857: warning: the frame size of 1872 bytes is larger than 1024 bytes Signed-off-by:
Prarit Bhargava <prarit@redhat.com> Signed-off-by:
-
Randy Dunlap authored
When CONFIG_ACPI_BUTTON=m (and probably when ACPI_BUTTON is not enabled) and NOUVEAU is built-in (not as a loadable module): nouveau_connector.c:(.text+0xe17ce): undefined reference to `acpi_lid_open' Signed-off-by:
Randy Dunlap <randy.dunlap@oracle.com> Acked-by:
Ben Skeggs <bskeggs@redhat.com> Signed-off-by:
-
Jerome Glisse authored
I think it's good to release the AGP bridge at suspend and reacquire it at resume. Also fix : https://bugzilla.kernel.org/show_bug.cgi?id=15969Signed-off-by:
Jerome Glisse <jglisse@redhat.com> Cc: stable <stable@kernel.org> Signed-off-by:
-
- 21 May, 2010 7 commits
-
-
Alex Deucher authored
This saves some more power at the expense of performance. Signed-off-by:
-
Dave Airlie authored
* nouveau/for-airlied: drm/nouveau: fix i2c-related init table handlers drm/nouveau: support init table i2c device identifier 0x81 drm/nouveau: ensure we've parsed i2c table entry for INIT_*I2C* handlers drm/nouveau: display error message for any failed init table opcode drm/nouveau: fix init table handlers to return proper error codes drm/nv50: support fractional feedback divider on newer chips drm/nv50: fix monitor detection on certain chipsets drm/nv50: store full dcb i2c entry from vbios drm/nv50: fix suspend/resume with DP outputs drm/nv50: output calculated crtc pll when debugging on drm/nouveau: dump pll limits entries when debugging is on drm/nouveau: bios parser fixes for eDP boards drm/nouveau: fix a nouveau_bo dereference after it's been destroyed drm/nv40: remove some completed ctxprog TODOs drm/nv04: Implement missing nv04 PGRAPH methods in software. drm/nouveau: Use 0x5f instead of 0x9f as imageblit on original NV10.
-
Dave Airlie authored
radeon needs power supply to get correct PM info so select it at the radeon level not at the kms option. Signed-off-by: -
Jerome Glisse authored
list reservation was too optimistic about ttm object reservation and could think that an object reserved by some other process as reserved by the list reservation which was false. Thus when unreserving the list it might unreserve object that it didn't reserved in the list. Sorry if it's hard to follow but this kind of things are just causing headheck. Signed-off-by:
-
Michel Dänzer authored
Fixes AGP initialization failure with Apple UniNorth bridges due to trying to ioremap() normal RAM. Signed-off-by:
-
Alex Deucher authored
Seems to cause issues with the sound hardware. Fixes kernel bug 15982: https://bugzilla.kernel.org/show_bug.cgi?id=15982Signed-off-by:
-
Alex Deucher authored
Spotted by Scott Bertilson. Fixes fdo bug 28146. Signed-off-by:
Mark Marshall <mark.marshall@csr.com> Signed-off-by:
-
- 19 May, 2010 6 commits
-
-
Ben Skeggs authored
Mutliple issues. INIT_ZM_I2C_BYTE/INIT_I2C_BYTE didn't even try and use the register value, and all the handlers were using the wrong slave address. Signed-off-by: -
Ben Skeggs authored
It appears to be meant to reference the second "default index". Signed-off-by: -
Ben Skeggs authored
We may not have parsed the entry yet if the i2c_index is for an i2c bus that's not referenced by a DCB encoder. This could be done oh so much more nicely, except we have to care about prehistoric DCB tables too, and they make life painful. Signed-off-by: -
Ben Skeggs authored
Some handlers don't report specific errors, but we still *really* want to know if we failed to parse a complete init table. Signed-off-by: -
Ben Skeggs authored
We really want to be able to distinguish between INIT_DONE and an actual error sometimes. This commit fixes up several lazy "return 0;" to be actual error codes, and explicitly reserves "0" as "success, but stop parsing this table". Signed-off-by: -
Ben Skeggs authored
Signed-off-by:
-
