Signed-off-by: Yann Dirson <ydirson@altern.org>
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de> (update)

fw_node() is not used (and not useful) outside fw-topology.c.
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

This duplicates the read cycle timer feature of raw1394 (added in Linux
2.6.21) in firewire-core's userspace ABI.  The argument to the ioctl is
reordered though to ensure 32/64 bit compatibility.
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>
Signed-off-by: Kristian Høgsberg <krh@redhat.com>

Check NodeID.nodeNumber as per OHCI 1.1 clause 7.2.3.2.  See also IEEE
1394a table 5B-1.

Also, demote the "node ID not valid" message from error to notification
as it is not an error condition.
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

at_context_queue_packet() didn't clean up in an early exit path.
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>
Signed-off-by: Kristian Høgsberg <krh@redhat.com>

Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

Add used includes, remove unused includes.
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

It seems unlikely, but access to self_id_cpu[0] could at least in theory
be deferred until after the loop over self_id_cpu[1..n] or even after
the subsequent reg_read.  Enforce the desired order by a read barrier.

Also prevent the reg_read from being reordered relative to the for loop.
This isn't necessary if the loop's conditional printk counts as an
implicit barrier, but better make it explicit.

(self_id_cpu[] is a coherent DMA buffer.)
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

Firewire-sbp2 did very uncooperative things in the kernel's shared
workqueue:  Sleeping until reception of management status from the
target for up to 2 seconds, and performing SCSI inquiry and all of the
setup of SCSI command set drivers via scsi_add_device.  If there were
transient or permanent error conditions, this caused long blockage of
the kernel's events process, noticeable e.g. by blocked keyboard input.

We now allocate a workqueue process exclusive to fw-sbp2.  As a side
effect, this also increases parallelism of fw-sbp2's login and reconnect
work versus fw-core's device discovery and device update work which is
performed in the shared workqueue.
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>
Signed-off-by: Kristian Høgsberg <krh@redhat.com>

On rare occasions, the ability to set one of the workaround flags at
runtime may save the day.

People who experience I/O errors with firewire-sbp2 while the old sbp2
driver worked for them should try workarounds=1 and report to the devel
mailinglist whether that improves things.  Firewire-sbp2 defaults to the
SCSI stack's maximum transfer size per command, while sbp2 limits them
to 128 kBytes.  Flag 1 accomplishes just that.
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

Fixes "New firewire stack only recognizing half of a chain of drives",
https://bugzilla.redhat.com/bugzilla/show_bug.cgi?id=242254Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

On IOMMU-less noncoherent architectures, orb->callback will memcpy the
whole SCSI command buffer for READ-like SCSI commands.  It is therefore
friendlier to enable IRQs before the call, like before patch "Add
ref-counting for sbp2 orbs".
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>
Acked-by: Kristian Høgsberg <krh@redhat.com>

Sparse warned about it although it was apparently harmless:

drivers/firewire/fw-cdev.c:624:23: warning: symbol 'interrupt' shadows an earlier one
include/asm/hw_irq.h:29:13: originally declared here
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

Potentially avoids unnecessary loop runs.
Guarantee quadlet-aligned starts of address regions.
Document the return values.
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

drivers/ieee1394/ieee1394_core.c: Define spinlock using
DEFINE_SPINLOCK instead of assignment to SPIN_LOCK_UNLOCKED
Signed-off-by: Matthias Kaehlcke <matthias.kaehlcke@gmail.com>
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

At least since nodemgr got rid of coarse global locking, accesses to
struct csr1212_keyval's reference counter should be atomic and coupled
with proper barriers.  Also, calls to csr1212_keep_keyval(kv) should
occur before kv is being used.

(We probably should convert refcnt to struct kref, but how to keep
csr1212_destroy_keyval's implementation non-recursively then?)
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

csr1212_keep_keyval(kv) in nodemgr_process_root_directory was
unbalanced if ne->vendor_name_kv already exists.  This happens for
example if eth1394 or raw1394 modify the local config ROM and it is
parsed again.

As a bonus, the attempt to add the vendor_name_kv sysfs attribute
when it already exists is now fixed for good.
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

* Delete optional and empty i2c client_register and client_unregister
  callbacks.
* Use the proper i2c adapter ID.
* Don't use a template to initialize the i2c_adapter structure, it's
  inefficient.
* Update a misleading comment on why we use i2c_transfer rather than
  higher level i2c functions.
Signed-off-by: Jean Delvare <khali@linux-fr.org>
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

The nodemgr host thread can exit on its own even when kthread_should_stop
is not true, on receiving a signal (might never happen in practice, as
it ignores signals). But considering kthread_stop() must not be mixed with
kthreads that can exit on their own, I think changing the code like this
is clearer. This change means the thread can cut its sleep short when
receive a signal but looking at the code around, that sounds okay (and
again, it might never actually recieve a signal in practice).
Signed-off-by: Satyam Sharma <satyam@infradead.org>
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

sbp2_host_reset and sbp2_handle_status_write are not serialized against
sbp2_alloc_device and sbp2_remove_device.
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

bad_proto can be reached from points which did not take priv->lock.
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

* git://git.kernel.org/pub/scm/linux/kernel/git/sam/kbuild: (40 commits)
  kbuild: introduce ccflags-y, asflags-y and ldflags-y
  kbuild: enable 'make CPPFLAGS=...' to add additional options to CPP
  kbuild: enable use of AFLAGS and CFLAGS on commandline
  kbuild: enable 'make AFLAGS=...' to add additional options to AS
  kbuild: fix AFLAGS use in h8300 and m68knommu
  kbuild: check for wrong use of CFLAGS
  kbuild: enable 'make CFLAGS=...' to add additional options to CC
  kbuild: fix up CFLAGS usage
  kbuild: make modpost detect unterminated device id lists
  kbuild: call export_report from the Makefile
  kbuild: move Kai Germaschewski to CREDITS
  kconfig/menuconfig: distinguish between selected-by-another options and comments
  kconfig: tristate choices with mixed tristate and boolean values
  include/linux/Kbuild: remove duplicate entries
  kbuild: kill backward compatibility checks
  kbuild: kill EXTRA_ARFLAGS
  kbuild: fix documentation in makefiles.txt
  kbuild: call make once for all targets when O=.. is used
  kbuild: pass -g to assembler under CONFIG_DEBUG_INFO
  kbuild: update _shipped files for kconfig syntax cleanup
  ...

Fix up conflicts in arch/um/sys-{x86_64,i386}/Makefile manually.

* 'upstream' of git://ftp.linux-mips.org/pub/scm/upstream-linus:
  [MIPS] Increase cp0 compare clockevent min_delta_ns from 0x30 to 0x300.
  [MIPS] Cache: Provide more information on cache policy on bootup.
  [MIPS] Fix aliasing bug in copy_user_highpage, take 2.
  [MIPS] VPE loader: convert from struct class_ device to struct device
  [MIPS] MIPSsim: Fix booting from NFS root
  [MIPS] Alchemy: Get rid of au1xxx_irq_map_t.
  [MIPS] Alchemy: Get rid of au_ffz().
  [MIPS] Alchemy: Get rid of au_ffs().
  [MIPS] Alchemy: cleanup interrupt code.
  [MIPS] Lasat: Fix build by conversion to irq_cpu.c.
  [MIPS] Lasat: Add #ifndef ... #endif include warpper to lasatint.h.
  [MIPS] IP22: Enable -Werror.
  [MIPS] IP22: Fix warning.
  [MIPS] IP22: Complain if requesting the front panel irq failed.
  [MIPS] vmlinux.lds.S: Handle KPROBES_TEXT.
  [MIPS] vmlinux.lds.S: Fix handling of .notes in final link.
  [MIPS] vmlinux.lds.S: Remove duplicate comment.
  [MIPS] MSP71XX: Add workarounds file.
  [MIPS] IP32: Fix build by conversion to irq_cpu.c.

Extremly low values are of dubious usefulness anyway but in this case
they actually were killing Qemu which simply wasn't able to complete
mips_next_event() within 0x30 100MHz cycles even on fast hosts.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

This should help making bug reports for the gadzillion of cores with all
their configuration and synthesis options more useful.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Turns out b868868a  wasn't quite right.
When called for a page that isn't marked dirty it would artificially
create an alias instead of doing the obvious thing and access the page
via KSEG0.

The same issue also exists in copy_to_user_page and copy_from_user_page
which was causing the machine to die under rare circumstances for example
when running ps if the BUG_ON() assertion added by the earlier fix was
getting triggered.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Kay Sievers <kay.sievers@vrfy.org>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

MIPSsim probably doesn't have any sort of environment, but writing
a zero in it kills even the compiled in command line. This prevents
booting via NFS root.
Signed-Off-By: Thiemo Seufer <ths@networkno.de>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

There were no users - and why have a private version anyway.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

It was plain a bad idea ...
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

  CC      arch/mips/sgi-ip22/ip22-berr.o
arch/mips/sgi-ip22/ip22-berr.c: In function 'ip22_be_interrupt':
arch/mips/sgi-ip22/ip22-berr.c:100: warning: passing argument 2 of 'die_if_kernel' discards qualifiers from pointer target type
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

This fixes the warning:

  CC      arch/mips/sgi-ip22/ip22-reset.o
arch/mips/sgi-ip22/ip22-reset.c: In function 'reboot_setup':
arch/mips/sgi-ip22/ip22-reset.c:239: warning: ignoring return value of 'request_irq', declared with attribute warn_unused_result
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>