Some of the existing code is flipping between __raw_xxx() and
pci_{read,write}_reg(). As the latter are just wrappers for the former,
flip over to using them consistently.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

Presently we error out if a link is disabled and simply drop the port
registration outright. This follows the PPC changes and simply reports on
the link state on boot, leaving the port registered, in order to more
easily deal with hotplug on future parts.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

These settings are properly propagated by the hardware already, so
there's no need to bother with them manually.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

The SH7786 PCIe is presently unable to enumerate itself in root complex
mode, and has no visibility through either type 0 or type 1 accesses,
despite having a mostly sensible extended config space for each port.
Attempts to generate type 0 or type 1 config cycles result in completer
aborts, so we're ultimately forced to use SuperHyway transactions
instead.

As each port has a single port <-> device mapping that resolves for any
PCI_SLOT definition, we simply hijack devfn 0 for the SuperHyway
transaction and bump up the devfn limit.

With enumeration of the root complex now possible, we also need to insert
an early fixup to hide the BARs from the kernel. With all of that done,
it's now possible to use the pcieport services with all of the PCIe
ports, which is the first step to power management support.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

Previously these IDs were only used by one driver, so there was not much
need for having them generically defined. Now that this will no longer
hold true, move them over.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

The spec suggests waiting up to 500ms for the PHY to settle before
testing link state, but practice shows that 100ms is sufficient (this is
the delay value we also use on the other SH-4A PCI controllers, too).
This makes device detection much more reliable, although in the future it
should be a bit faster to simply serialize with a TLP IRQ.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

After configuration accesses have been completed deassert the
configuration access enable cleanly.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

The _remove() routine is flagged __init_or_module, despite only being
used in a __devexit context. As the rest of the driver is already
balanced out with __devinit, switch to __devexit and __devexit_p()
wrapping.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

The current probe/remove definitions are split between __init and
__devexit, make them consistent by switching to __devinit.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

The only BKL user in arch/sh protects a single bit,
so we can trivially replace it with test_and_set_bit.
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Cc: Paul Mundt <lethal@linux-sh.org>
Cc: linux-sh@vger.kernel.org
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

According to Morimoto-san, this is no longer needed. Revert it.

This reverts commit e0009b0a.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

Now that the rest of the socket calls are provided through their own
paths, do the same for sys_recvmmsg. It's unlikely we'll ever be able to
kill off the socketcall path, but this at least permits userspace to
gradually begin migrating.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

Linux kernel already has socket syscalls that can be invoked
without the multiplexing sys_socketcall wrapper.
C library wrappers are ready to use them directly. It needs just
to define the missing syscall numbers and provide the related entries
into the syscalls table, like sh64 aleady does.
Signed-off-by: Francesco Rundo <francesco.rundo@st.com>
Signed-off-by: Carmelo Amoroso <carmelo.amoroso@st.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

This patch modify x_plate_ohms to correct value for tsc2007 panel,
and removed un-necessary ts_get_pendown_state()
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

As the help for the config option suggests, this option really shouldn't
be set by default for any recent distribution as it changes the layout
of sysfs. I spotted this while running debian when udev got very
confused by the sysfs layout and failed to create some device nodes.
Signed-off-by: Matt Fleming <matt@console-pimps.org>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

Now that the resource assignment issues are resolved, we can finally wire
up the small third memory window -- in the future we may reclaim this for
MSI.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

An IORESOURCE_IO was missing here, which meant that we weren't properly
establishing the I/O window for this particular slot. With this
corrected, cards with I/O BARs have them actually assigned and
accessible.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

Certain memory windows are only available for 32-bit space, so skip over
these in 29-bit mode. This will severely restrict the amount of memory
that can be mapped, but since a boot loader bug makes booting in 29-bit
mode close to impossible anyways, everything is ok.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

This bumps up the low address to match the physical memory windows for
SHway<->PCIe transfers. The previous implementation was banking on a 1:1
virt<->phys SHway mapping, which doesn't apply here.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

This attempts a more complete port reset, building on top of the existing
approach.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

Signed-off-by: Matt Fleming <matt@console-pimps.org>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

Conflicts:
	arch/sh/kernel/process_32.c
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

These were newly added while the defconfig reduction work was ongoing,
strip them down now.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

SH7786 PCIe has 1 slot per port, but no specific restriction on function.
Relax the devfn restriction and look to the slot number instead when
configured as a root complex.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

This was killed off by a simplification patch previously that failed to
take the cpufreq use case in to account, so reinstate the old bounding
logic. The lowest rate bounding on the other hand was broken in that it
never actually got assigned a rate and the best fit rate was instead just
getting lucky based on the ordering of the rate table, fix this up so the
code actually does what it was intended to do originally.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

This brings the clocking and register setting in line with the somewhat
factually ambiguous specification.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

This enables support for type 1 config space accesses on the SH7786
PCI controller. At the same time, add in some extra sanity checks for
controller asserted errors.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

* 'bugfixes' of git://git.linux-nfs.org/projects/trondmy/nfs-2.6:
  NFS: Fix an Oops in the NFSv4 atomic open code
  NFS: Fix the selection of security flavours in Kconfig
  NFS: fix the return value of nfs_file_fsync()
  rpcrdma: Fix SQ size calculation when memreg is FRMR
  xprtrdma: Do not truncate iova_start values in frmr registrations.
  nfs: Remove redundant NULL check upon kfree()
  nfs: Add "lookupcache" to displayed mount options
  NFS: allow close-to-open cache semantics to apply to root of NFS filesystem
  SUNRPC: fix NFS client over TCP hangs due to packet loss (Bug 16494)

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jikos/hid:
  USB HID: Add ID for eGalax Multitouch used in JooJoo tablet
  HID: hiddev: fix memory corruption due to invalid intfdata
  HID: hiddev: protect against disconnect/NULL-dereference race
  HID: picolcd: correct ordering of framebuffer freeing
  HID: picolcd: testing the wrong variable

* 'release' of git://git.kernel.org/pub/scm/linux/kernel/git/aegl/linux-2.6:
  [IA64] Fix build error: conflicting types for ‘sys_execve’

Fix the declaration of sys_execve() in asm-generic/syscalls.h to have
various consts applied to its pointers.
Signed-off-by: David Howells <dhowells@redhat.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

arch/ia64/kernel/process.c:636: error: conflicting types for ‘sys_execve’

commit d7627467
Make do_execve() take a const filename pointer

Missed the declaration of sys_execve in the ia64 asm/unistd.h (perhaps
because there is no reason for it to be there ... it might be a left over
from the COMPAT code?). Just delete the conflicting version.
Signed-off-by: Tony Luck <tony.luck@intel.com>

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/viro/vfs-2.6:
  fs: brlock vfsmount_lock
  fs: scale files_lock
  lglock: introduce special lglock and brlock spin locks
  tty: fix fu_list abuse
  fs: cleanup files_lock locking
  fs: remove extra lookup in __lookup_hash
  fs: fs_struct rwlock to spinlock
  apparmor: use task path helpers
  fs: dentry allocation consolidation
  fs: fix do_lookup false negative
  mbcache: Limit the maximum number of cache entries
  hostfs ->follow_link() braino
  hostfs: dumb (and usually harmless) tpyo - strncpy instead of strlcpy
  remove SWRITE* I/O types
  kill BH_Ordered flag
  vfs: update ctime when changing the file's permission by setfacl
  cramfs: only unlock new inodes
  fix reiserfs_evict_inode end_writeback second call

This fixes a build breakage introduced by commit 4c2ef25f ("mmc: fix
all hangs related to mmc/sd card insert/removal during suspend/resume")

Cc: David Brownell <david-b@pacbell.net>
Cc: Alan Stern <stern@rowland.harvard.edu>
Cc: linux-mmc@vger.kernel.org
Cc: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Acked-by: Kukjin Kim <kgene.kim@samsung.com>
Acked-by: Maxim Levitsky <maximlevitsky@gmail.com>
Acked-by: Randy Dunlap <randy.dunlap@oracle.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

Merge branch 'perf-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip

* 'perf-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip:
  perf tools: Fix build on POSIX shells
  latencytop: Fix kconfig dependency warnings
  perf annotate tui: Fix exit and RIGHT keys handling
  tracing: Sanitize value returned from write(trace_marker, "...", len)
  tracing/events: Convert format output to seq_file
  tracing: Extend recordmcount to better support Blackfin mcount
  tracing: Fix ring_buffer_read_page reading out of page boundary
  tracing: Fix an unallocated memory access in function_graph

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound-2.6:
  ALSA: emu10k1 - delay the PCM interrupts (add pcm_irq_delay parameter)
  ALSA: hda - Fix ALC680 base model capture
  ASoC: Remove DSP mode support for WM8776
  ALSA: hda - Add quirk for Dell Vostro 1220
  ALSA: riptide - Fix detection / load of firmware files

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/gerg/m68knommu:
  m68knommu: include sched.h in ColdFire/SPI driver
  m68knommu: formatting of pointers in printk()
  m68knommu: arch/m68k/include/asm/ide.h fix for nommu