- 20 Nov, 2011 3 commits
-
-
Mauro Carvalho Chehab authored
Signed-off-by:Mauro Carvalho Chehab <mchehab@redhat.com>
-
Eddi De Pieri authored
With this patch I try again to add initial support for HVR930C. Tested only DVB-T, since in Italy Analog service is stopped. Actually "scan -a0 -f1", find only about 50 channel while 400 should be available. [mchehab@redhat.com: Tested with DVB-C and fixed a few whitespace issues] Tested-by:
Eddi De Pieri <eddi@depieri.net> Signed-off-by:
-
Mauro Carvalho Chehab authored
This is needed for devices with DRX-K and xc5000. Tested with a HVR 930C hardware. Signed-off-by:
-
- 16 Nov, 2011 1 commit
-
-
Mauro Carvalho Chehab authored
As reported by Andreas Oberritter <obi@linuxtv.org>, changeset 33ba28ee did the wrong thing. Fix it to properly reflect the entries for Terratec H5 revs 1 and 2, and restore Terratec XS entry. Signed-off-by:
-
- 11 Nov, 2011 2 commits
-
-
Mauro Carvalho Chehab authored
The Annex C support were broken with the previous implementation, as, at xc5000 and tda18271c2dd, it were choosing the wrong bandwidth for some symbol rates. At DRX-J, it were always selecting Annex A, even having Annex C support coded there. Signed-off-by: -
Mauro Carvalho Chehab authored
DVB-C, as defined by ITU-T J.83 has 3 annexes. The differences between Annex A and Annex C is that Annex C uses a subset of the modulation types, and uses a different rolloff factor. A different rolloff means that the bandwidth required is slicely different, and may affect the saw filter configuration at the tuners. Also, some demods have different configurations, depending on using Annex A or Annex C. So, allow userspace to specify it, by changing the rolloff factor. Signed-off-by:
-
- 08 Nov, 2011 33 commits
-
-
Hans Verkuil authored
Signed-off-by:
Hans Verkuil <hans.verkuil@cisco.com> Signed-off-by:
-
Hans Verkuil authored
Signed-off-by:
-
Hans Verkuil authored
Signed-off-by:
-
Hans Verkuil authored
Move all USB radio devices to the top of the list and move all ISA devices to a separate menu. Signed-off-by:
-
Hans Verkuil authored
Thanks to Guennadi Liakhovetski <g.liakhovetski@gmx.de> for pointing this out to me. Signed-off-by:
-
Hans Verkuil authored
Signed-off-by:
-
Hans Verkuil authored
These are really, really old drivers. These are really no longer experimental... Signed-off-by:
-
Hans Verkuil authored
Signed-off-by:
-
Hans Verkuil authored
USB webcams are some of the most used V4L devices, so move it to a more prominent place in the menu instead of being at the end. Signed-off-by:
-
Jean Delvare authored
The support for 10-bit I2C addresses in usbvision seems plain broken to me. I had already noticed that back in February 2007 [1]. The code was not fixed since then, so I take it that it's not actually needed. And as a matter of fact I don't know of any 10-bit addressed I2C tuner, encode, decoder or the like. So let's simply get rid of the broken and useless code. I'm also adding I2C_FUNC_I2C, as the driver and hardware support plain I2C messaging. [1] http://marc.info/?l=linux-i2c&m=117499415208244&w=2Signed-off-by:
Jean Delvare <khali@linux-fr.org> Signed-off-by:
-
Malcolm Priestley authored
This indeed a clone of Kworld UB499 2T Signed-off-by:
Malcolm Priestley <tvboxspy@gmail.com> Signed-off-by:
-
Sylwester Nawrocki authored
Remove pre-processor defined as10x_handle_t data type by directly replacing it with struct as102_bus_adapter_t. phandle is renamed to adap inside function bodies. Cc: Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by:
Sylwester Nawrocki <snjw23@gmail.com> Signed-off-by:
-
Sylwester Nawrocki authored
Supresses following checkpatch warning: WARNING: static const char * array should probably be static const char * const Cc: Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by:
-
Sylwester Nawrocki authored
Fixes following checkpatch.pl warning: WARNING: externs should be avoided in .c files Cc: Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by:
-
Sylwester Nawrocki authored
Cc: Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by:
-
Sylwester Nawrocki authored
The as10x_cmd.h header is not public so there should be no need for an "extern "C"" in it. Cc: Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by:
-
Sylwester Nawrocki authored
While at it also correct some spelling errors. Cc: Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by:
-
Sylwester Nawrocki authored
Remove some unnecessary braces. Replace spaces with tabs where expected. Replace gcc specific __FUNCTION__ with C99 __func__. No functional changes. Cc: Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by:
-
Sylwester Nawrocki authored
Release already acquired resources when error happens during devices registration steps. Use dev_err() where struct device is available, instead of driver specific err(). Cc: Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by:
-
Sylwester Nawrocki authored
Cc: Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by:
Piotr Chmura <chmooreck@poczta.onet.pl> Signed-off-by:
-
Sylwester Nawrocki authored
It doesn't seem to be of much advantage to compile in FW_LOADER support conditionally, then make the driver always select FW_LOADER and remove #idefs from the code. Cc: Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by:
-
Sylwester Nawrocki authored
SPI bus driver support is not included in this module, the SPI driver files are missing. But some bits are still present so clean up the unused code. The SPI driver support can be properly added later if needed. Then CONFIG_AS102_SPI and CONFIG_AS102_USB is now not needed and the pre-processor statements using these config options can now be removed from *.c files. Cc: Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by:
-
Sylwester Nawrocki authored
According to the kernel coding rules typedefs should be avoided, so replace theit occurances with explicit enum/union types. Cc: Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by:
-
Piotr Chmura authored
Cc: Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by:
-
Malcolm Priestley authored
Correction of reading from frontend and represents a SNR nonlinear scale of minimum signal to full signal. Signed-off-by:
-
Peter De Schrijver authored
add support for conexant PCI device 0x36c. Seems to be fully compatible with the currently supported chips, yet the chip has different PCI ID. Signed-off-by:
Peter De Schrijver <p2@psychaos.be> Signed-off-by:
-
Peter De Schrijver authored
The following patch adds support for the Tongwei Video Technology TD-3116 board. This is a Bt878 based capture card with 16 inputs meant for surveilance applications. It also offers a way to check which inputs have a video signal while capturing another input. In addition there are a number of alarm inputs and outputs available and there is microcontroller which is presumably intended for use as a system watchdog. None of these extra capabilities are supported by the patch. Signed-off-by:
-
Malcolm Priestley authored
IT9135 devices do support USB 1. Support added with restricton on pid count to 5. IT9137 devices wil not connect in USB 1 mode. Signed-off-by:
-
Javier Martinez Canillas authored
64933337 [media] tvp5150: Add video format registers configuration values Added constants for each video standard supported by TVP5150, so this patch get rid of the magic numbers. Signed-off-by:
Javier Martinez Canillas <martinez.javier@gmail.com> Signed-off-by:
-
Kamil Debski authored
G2D is a 2D graphics accelerator engine present in the s5p family of Samsung SoCs. It is capable of bitblt and raster operations on images having dimensions of up to 8000x8000. Signed-off-by:
Kamil Debski <k.debski@samsung.com> Signed-off-by:
Kyungmin Park <kyungmin.park@samsung.com> Signed-off-by:
Marek Szyprowski <m.szyprowski@samsung.com> Signed-off-by:
-
Michael Krufky authored
Reported-by:
Antti Palosaari <crope@iki.fi> Signed-off-by:
Michael Krufky <mkrufky@linuxtv.org> Signed-off-by:
-
Michael Krufky authored
Reported-by:
-
Michael Krufky authored
Reported-by:
-
- 07 Nov, 2011 1 commit
-
-
Josh Boyer authored
The ttusb2_msg function uses on-stack variables to submit commands to dvb_usb_generic. This eventually gets to the DMA api layer and will throw a traceback if the debugging options are set. This allocates the temporary buffer variables with kzalloc instead. Fixes https://bugzilla.redhat.com/show_bug.cgi?id=734506Signed-off-by:
Josh Boyer <jwboyer@redhat.com> Signed-off-by:
-
