An error occurred fetching the project authors.
- 07 Nov, 2005 40 commits
-
-
James Ketrenos authored
with request_scan being called before initialized if invoked from insmod, resulting in no association occurring during boot until iwlist scan is run. Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
Zhu Yi authored
Signed-off-by: Zhu Yi <yi.zhu@intel.com>
-
Zhu Yi authored
Signed-off-by: Zhu Yi <yi.zhu@intel.com>
-
Zhu Yi authored
Signed-off-by: Zhu Yi <yi.zhu@intel.com>
-
Hong Liu authored
If we configure the wep keys after creating the ibss network, the beacons of this network will not show correctly (it still shows "key off" in iwlist scan report). This is because we don't update the beacon info in firmware. Signed-off-by: Hong Liu <hong.liu@intel.com> Signed-off-by: Zhu Yi <yi.zhu@intel.com>
-
Zhu Yi authored
Signed-off-by: Zhu Yi <yi.zhu@intel.com>
-
Zhu Yi authored
support hardware fragmentation. Signed-off-by: Zhu Yi <yi.zhu@intel.com>
-
Zhu Yi authored
Signed-off-by: Zhu Yi <yi.zhu@intel.com>
-
James Ketrenos authored
iwconfig matches what their hardware can actually do in regard to supported channel maps, etc. Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
James Ketrenos authored
Updated a copyright date. Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
James Ketrenos authored
support. Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
James Ketrenos authored
(vs. 9 which is too low in most environments) Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
Liu Hong authored
It uses the ieee80211-geo info to set the tx power of the a/b/g band. Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
Zhu Yi authored
We send SYSTEM_CONFIG command after the TGI_KEY command if hardware encryption is enabled. It sometimes causes a firmware stall (firmware doesn't respond to any request) and finally bungs up the Tx send queue. The solution is to send SYSTEM_CONFIG command in the post association stage from a workqueue. Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
Zhu Yi authored
Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
Zhu Yi authored
Firmware sends received packets with double sized ICV/MIC. Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
James Ketrenos authored
* Fixed #452 problem with setting retry limit (thanks to Hong Liu) * Fixed #592 race condition during association causing firmware errors * Fixed #602 problem with building in 64-bit environment * Fixed #625 problem with SCAN_REQUEST_EXT sometimes failing * Fixed #645 problem with bit rate not decreasing when moving laptop farther from AP * Fixed #656 problem with 'iwconfig eth1 mode auto' and 'modprobe' locking the system * Fixed #667 problem with "No space for Tx" for hwcrypto=1 * Fixed #685 kernel panic in rmmod caused by led work is still queued * Fixed #695 problem with network doesn't reassociate after suspend/resume * Fixed #701 problem with 'iwprvi sw_reset' not resetting the card from monitor mode * Fixed #710 problem with monitor mode being used after a WEP key has been configured * Fixed network->mode vs. priv->ieee->iw_mode checking (thanks to Ben Cahill) * Fixed "Unknown management packet %d" warning * Fixed setting channels multiple times in monitor mode causes scan stopped * Fixed ipw_wx_sw_reset doesn't switch firmware if mode is changed. * Add duplicate packet checking code (kill ping DUP! and TKIP replay warning) * Fix hardware encryption (both WEP and AES) doesn't work with fragmentation. Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
Zhu Yi authored
support wpa_supplicant with open AP. We need this to make driver_ipw work. driver_ext has already had the similar code with the WE-18 support added. Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
Liu Hong authored
Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
James Ketrenos authored
* Added WE-18 support. This allows the use of -Dext with wpa_supplicant > 0.4.x (thanks to Hong Liu) * Fixed #339 problem with iwconfig set/get txpower (thanks to Hong Liu) * Fixed #598 problem when with error messages when module loaded with 'disable=1' (thanks to Hong Liu) * Fixed #640 problem with 'iwlist retry' now showing min/max retry * Fixed compatibility with wpa_supplicant and the new -Dipw interface (that included a fix for 64-bit compatibility) * Added CFG_CRC_CHECK which allows passing through packets with bad CRCs while in monitor mode. Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
James Ketrenos authored
* Fixed #627 problem with open APs not working with wpa_supplicant * Fixed #632 problem with 'txpower auto' setting power incorrectly (thanks to Kai Groner) * Fixed #634 problem with 'iwconfig eth1 frag 0' hanging the shell * Fixed problem with adapter not fully powering off during suspend to RAM or when module unloaded. * Fixed #645 problem with turning fixed rates off not taking effect until you reload the driver * Fixed problem with firmware restart if wpa_supplicant was used to set a key that wasn't exactly 5 or 13 bytes in length. * Fixed #623 Added iwpriv sw_reset extension to reset sw parameters * Added managment frame export to user space with frame statistics * Fixed #652 Modified the driver to load the EEPROM data even if RF KILL is active during driver load * Global s:CX2_:IPW_:g to make code more consistent * Fixed #572 problem with setting txpower to auto * Fixed #656 problem with kernel oops if mode auto; modprobe -r ipw2200 * Added QoS (CONFIG_IPW_QOS) support. This is being actively developed but is the first step in getting WMM support into the driver and the kernel. * Fixed some race conditions with channel changes, association, and scan abort that could periodically cause a firmware restart. * Added some extensions to export scan and network statistics to user space (exposed through speed_scan and net_stats sysfs entries) * Fixed a few bugs in how monitor mode was supported (scan lists weren't quite right) * Updated the firmware requirement from 2.2 to 2.3 which supports monitor mode. Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
James Ketrenos authored
* Fix #616 problem with OOPS on module load (thanks to Yi Zhu) * Fixed problem with led module parameter being described as 'auto_create' * Added support to merge between adhoc networks (thanks to Mohamed Abbas) * Added semaphore lock at the driver's entry points to protect against re-entry (thanks to Mohamed Abbas) * Added semaphore lock to background scheduled driver actions (thanks to Mohamed Abbas) * Changed how signal quality is reported for scan output (thanks to Peter Jones) * Fixed how high/low clamp values of signal quality are reported so a more consistent ramp is provided (thanks to Bill Moss) * Fix #624 problem with duplicate addresses (again) (thanks to Bernard Blackham) * Fix #385 problem with fragmentation and certain sized packets (thanks to Mohamed Abbas) * Modified iwconfig network name if RF kill is enabled to say 'radio off' * Fix #382 problem with driver not responding to probe requests in Ad-Hoc mode (thanks to Mohamed Abbas) Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
James Ketrenos authored
Removed unneeded parenthesis around numeric constant defines Added support for iwspy Put in fix for Ad-Hoc mode not passing through all packets (thanks to KKH) Put in fix for fragmentation not working for fragment sizes between 441-464 bytes (thanks to Mohamed Abbas) Fixed #592 problem of CONFIG_IEEE80211_WPA_MODULE not including WPA support into the driver -- fixed as a result of no longer limiting WPAs inclusion Fixed #594 problem with user rates mask causing lack of association if AP mandatory rate is masked out. We now add back in as a supported rate any mandatory rate. Fixed #597 kernel oops due to calling dev_kfree_skb on an skb multiple times. Added code to control LEDs that can be controlled through the wireless NIC (vs. non-wireless HW interfaces) -- this is currently disabled by default due to reports by some users of it hanging their laptop. Added some more debug messages around fragmentation logic Added locking around STATUS_HCMD_ACTIVE to prevent re-entry race conditions Moved ipw_adapter_restart to only execute on the priv->workqueue to keep keyboard errors from occuring during adapter restart Added CFG_BACKGROUND_SCAN to easily allow people to play with background scanning implementations Modified WPA logic to send WPA IE if one is set (vs. being based on wpa_enabled) Modified scan result logic to report WPA and RSN IEs if set (vs. being based on wpa_enabled) Fixed issues with endianess compatability between the host and wireless adapter (thanks to York Liu and Yi Zhu) Fixed problem with Ad-Hoc network creation causing a firmware error if a scan was actively running (thanks to Mohamed Abbas) Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
James Ketrenos authored
This commit contains the following fixes: Fixed #559: iwconfig rate support (thanks to Florian Hackenberger) Improved link signal quality calculation (thanks to Bill Moss) Fixed a problem with sensitivity threshold during association Added iwpriv for turning forcing long preamble support: % iwpriv eth1 set_preamble 1|0 Fixed #542 and #377 support for short preamble Fixed locked BSSID reporting channel number (thanks to Pedro Ramalhais) Fixed type-o with scan watchdog timeout message (thanks to Pedro Ramalhais) Changed logic for displaying get_mode output so the code is easier to follow (thanks to Pedro Ramalhais) Added initial support for WPA (thanks to Yi Zhu) -- tested with wpa_supplicant (either tip w/ ipw driver, or with -Dipw2100) with both CCMP and TKIP Fixed problem with CCMP not working due to uninitialized 802.11 header fields (thanks to Pedro Ramalhais) Bug references are to defects stored on http://bughost.orgSigned-off-by: James Ketrenos <jketreno@linux.intel.com>
-
Zhu Yi authored
-
James Ketrenos authored
No other changes. Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
James Ketrenos authored
-
Volker Braun authored
The functions ieee80211_wx_{get,set}_encodeext fail if one tries to set unicast (IW_ENCODE_EXT_GROUP_KEY not set) keys at key indices>0. But at least some Cisco APs dish out dynamic WEP unicast keys at index !=0. Signed-off-by: Volker Braun <volker.braun@physik.hu-berlin.de> Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
James Ketrenos authored
Signed-off-by: James Ketrenos <jketreno@linux.intel.com>
-
Francois Romieu authored
Don't request_irq before the registers are reset/init. Signed-off-by: Francois Romieu <romieu@fr.zoreil.com> Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
-
Francois Romieu authored
There is no need to save/restore the irq state as the irq are always locally disabled when b44_interrupt is issued. Signed-off-by: Francois Romieu <romieu@fr.zoreil.com> Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
-
Francois Romieu authored
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com> Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
-
Francois Romieu authored
- remove unneeded forward declarations - s/kmalloc + memset/kzalloc/ - whitespace readjustement can't hurt - wrong comment: b44_init_rings _is_ called with a spinlock held in b44_{open/set_ringparam/set_pauseparam/etc}. Actually, it does not need to be able to sleep - b44_remove_one() can not be issued with a NULL device in its private member: remove the test. Signed-off-by: Francois Romieu <romieu@fr.zoreil.com> Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
-
Francois Romieu authored
The patch simply factors out the release of the lock. Signed-off-by: Francois Romieu <romieu@fr.zoreil.com> Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
-
Jeff Garzik authored
-
Linus Torvalds authored
-
Linus Torvalds authored
-
Linus Torvalds authored
-
Linus Torvalds authored
-