- 08 Nov, 2012 40 commits
-
-
Lars Ellenberg authored
When the last volume of a replication group is unconfigured, the worker thread exits. To not interfere with cleanup of other threads, before the the last cleanups run, we need to make sure the receiver has already exited. The commend explaining that clearly belongs above drbd_thread_stop(&tconn->receiver), not in the cleanup loop below. Signed-off-by:
Philipp Reisner <philipp.reisner@linbit.com> Signed-off-by:
Lars Ellenberg <lars.ellenberg@linbit.com>
-
Lars Ellenberg authored
Signed-off-by:
-
Lars Ellenberg authored
We use our own copy of kernel_setsockopt, and did not mess around with get_fs/set_fs, since we thought we knew we would always be KERNEL_DS anyways. Apparently not so for at least user mode linux, so put the set_fs(KERNEL_DS) in there. Signed-off-by:
-
Lars Ellenberg authored
We had drbd_adm_get_status (one single volume), and drbd_adm_get_status_all (dump of all volumes of all resources). This enhances the latter to be able to dump all volumes of just one specific resource. Signed-off-by:
-
Philipp Reisner authored
Now since it is possible to change the two_primaries config flag while the connection is up, make sure we treat a peer_req in a consistent way if the config flag changes while the peer_req is under IO. Signed-off-by:
-
Philipp Reisner authored
Removing the get_net_conf()/put_net_conf() functions Signed-off-by:
-
Philipp Reisner authored
Removing the get_net_conf()/put_net_conf() calls Signed-off-by:
-
Philipp Reisner authored
Signed-off-by:
-
Philipp Reisner authored
Signed-off-by:
-
Philipp Reisner authored
The wire protocol is no longer a property that is negotiated between the two peers. It is now expressed with two bits (DP_SEND_WRITE_ACK and DP_SEND_RECEIVE_ACK) in each data packet. Therefore the primary node is free to change the wire protocol at any time without disconnect/reconnect. Signed-off-by:
-
Philipp Reisner authored
With this commit the locking for all accesses to IDRs is complete: * Non sleeping read accesses are protected by RCU * sleeping read accesses are protocted by a read lock on drbd_cfg_rwsem * accesses that add anything are protected by a write lock * accesses that remove an object are protoected by a write lock and a call to synchronize_rcu() after it is removed from the IDR and before the object is actually free()ed. Signed-off-by:
-
Philipp Reisner authored
Signed-off-by:
-
Philipp Reisner authored
Signed-off-by:
-
Philipp Reisner authored
Signed-off-by:
-
Philipp Reisner authored
Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
drbd: Rename reclaim_net_ee(), drbd_process_done_ee(), drbd_process_done_ee(), tconn_process_done_ee() to *_peer_reqs Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
Since have now header 100, that has space for 16 bit volume numbers, the high byte of the length in header 95 is no longer reserved for 8 bit volume numbers. Signed-off-by:
-
Andreas Gruenbacher authored
The 8 byte header finally becomes too small. With the protocol 100 header we have 16 bit for the volume number, proper 32 bit for the data length, and 32 bit for further extensions in the future. Previous versions of drbd are using version 80 headers for all packets short enough for protocol 80. They support both header versions in worker context, but only version 80 headers in asynchronous context. For backwards compatibility, continue to use version 80 headers for short packets before protocol version 100. From protocol version 100 on, use the same header version for all packets. Signed-off-by:
-
Andreas Gruenbacher authored
Prepare the introduction of the protocol 100 headers. The actual protocol header is removed for the packet declarations. I.e. allow us to use the packets with different headers. Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
Centralize sock->mutex locking and unlocking in [drbd|conn]_prepare_command() and [drbd|conn]_send_comman(). Therefore all *_send_* functions are touched to use these primitives instead of drbd_get_data_sock()/drbd_put_data_sock() and former helper functions. That change makes the *_send_* functions more standardized. Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Andreas Gruenbacher authored
Signed-off-by:
-
Philipp Reisner authored
Signed-off-by:
-
Philipp Reisner authored
Signed-off-by:
-
Philipp Reisner authored
Signed-off-by:
-
Philipp Reisner authored
Signed-off-by:
-
