Commit c42850f1 authored by Andy Shevchenko's avatar Andy Shevchenko Committed by Greg Kroah-Hartman

serial: 8250_mid: recognize interrupt source in handler

There is a special register that shows interrupt status by source. In
particular case the source can be a combination of DMA Tx, DMA Rx, and UART.

Read the register and call the handlers only for sources that request an
interrupt.

Fixes: 6ede6dcd ("serial: 8250_mid: add support for DMA engine handling from UART MMIO")
Cc: stable@vger.kernel.org
Reviewed-by: default avatarHeikki Krogerus <heikki.krogerus@linux.intel.com>
Signed-off-by: default avatarAndy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 107e15fc
......@@ -25,6 +25,7 @@
#define PCI_DEVICE_ID_INTEL_DNV_UART 0x19d8
/* Intel MID Specific registers */
#define INTEL_MID_UART_DNV_FISR 0x08
#define INTEL_MID_UART_PS 0x30
#define INTEL_MID_UART_MUL 0x34
#define INTEL_MID_UART_DIV 0x38
......@@ -90,16 +91,16 @@ static int tng_setup(struct mid8250 *mid, struct uart_port *p)
static int dnv_handle_irq(struct uart_port *p)
{
struct mid8250 *mid = p->private_data;
int ret;
ret = hsu_dma_irq(&mid->dma_chip, 0);
ret |= hsu_dma_irq(&mid->dma_chip, 1);
/* For now, letting the HW generate separate interrupt for the UART */
if (ret)
return ret;
return serial8250_handle_irq(p, serial_port_in(p, UART_IIR));
unsigned int fisr = serial_port_in(p, INTEL_MID_UART_DNV_FISR);
int ret = IRQ_NONE;
if (fisr & BIT(2))
ret |= hsu_dma_irq(&mid->dma_chip, 1);
if (fisr & BIT(1))
ret |= hsu_dma_irq(&mid->dma_chip, 0);
if (fisr & BIT(0))
ret |= serial8250_handle_irq(p, serial_port_in(p, UART_IIR));
return ret;
}
#define DNV_DMA_CHAN_OFFSET 0x80
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment