staging: mt7621-mmc: Remove code for different soc types

Remove code that is intended for soc other then the mt7621 because
this driver is only for that soc. This also removes some conditions.
However the remaining code is also at the wrong place, it just selects
the mode of the pins, this is a job for pinctl not for the sdxc driver.
Signed-off-by: Christian Lütke-Stetzkamp <christian@lkamp.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/staging/mt7621-mmc/sd.c

@@ -2987,27 +2987,10 @@ static int __init mt_msdc_init(void)
 
 	printk("MTK MSDC device init.\n");
 	mtk_sd_device.dev.platform_data = &msdc0_hw;
-	if (ralink_soc == MT762X_SOC_MT7620A || ralink_soc == MT762X_SOC_MT7621AT) {
-//#if defined (CONFIG_RALINK_MT7620) || defined (CONFIG_RALINK_MT7621)
-		reg = sdr_read32((volatile u32 *)(RALINK_SYSCTL_BASE + 0x60)) & ~(0x3 << 18);
-//#if defined (CONFIG_RALINK_MT7620)
-		if (ralink_soc == MT762X_SOC_MT7620A)
-			reg |= 0x1 << 18;
-//#endif
-	} else {
-//#elif defined (CONFIG_RALINK_MT7628)
-		/* TODO: maybe omitted when RAether already toggle AGPIO_CFG */
-		reg = sdr_read32((volatile u32 *)(RALINK_SYSCTL_BASE + 0x3c));
-		reg |= 0x1e << 16;
-		sdr_write32((volatile u32 *)(RALINK_SYSCTL_BASE + 0x3c), reg);
-
-		reg = sdr_read32((volatile u32 *)(RALINK_SYSCTL_BASE + 0x60)) & ~(0x3 << 10);
-#if defined(CONFIG_MTK_MMC_EMMC_8BIT)
-		reg |= 0x3 << 26 | 0x3 << 28 | 0x3 << 30;
-		msdc0_hw.data_pins      = 8,
-#endif
-//#endif
-	}
+
+	// Set the pins for sdxc to sdxc mode
+	//FIXME: this should be done by pinctl and not by the sd driver
+	reg = sdr_read32((volatile u32 *)(RALINK_SYSCTL_BASE + 0x60)) & ~(0x3 << 18);
 	sdr_write32((volatile u32 *)(RALINK_SYSCTL_BASE + 0x60), reg);
 	//platform_device_register(&mtk_sd_device);
 /* end of +++ */