- 03 Jan, 2011 11 commits
-
-
Fabio Estevam authored
Signed-off-by:
Fabio Estevam <fabio.estevam@freescale.com> Signed-off-by:
Sascha Hauer <s.hauer@pengutronix.de>
-
Fabio Estevam authored
Signed-off-by:
-
Fabio Estevam authored
Signed-off-by:
-
Fabio Estevam authored
Signed-off-by:
-
git://git.pengutronix.de/git/ukl/linux-2.6Sascha Hauer authored
Merge branch 'sgu/mxs-core-v8' of git://git.pengutronix.de/git/ukl/linux-2.6 into imx-for-2.6.38-new
-
Richard Zhao authored
Add basic function and uart device support. Signed-off-by:
Richard Zhao <richard.zhao@freescale.com> Signed-off-by:
-
Richard Zhao authored
Add core definitions and memory map, gpio, irq, iomux, uart device support. Signed-off-by:
-
Richard Zhao authored
Signed-off-by:
Uwe Kleine-König <u.kleine-koenig@pengutronix.de> Signed-off-by:
-
Richard Zhao authored
mx5 SoCs have different GPIO port count. Signed-off-by:
-
Richard Zhao authored
Signed-off-by:
-
Richard Zhao authored
Signed-off-by:
-
- 20 Dec, 2010 13 commits
-
-
Shawn Guo authored
Signed-off-by:
Shawn Guo <shawn.guo@freescale.com> Signed-off-by:
-
Shawn Guo authored
Add initial mx28evk support with duart and fec0. Signed-off-by:
-
Shawn Guo authored
Add initial mx23evk support with duart. Signed-off-by:
-
Shawn Guo authored
Dynamically allocate fec devices for MX28, which gets dual fec interface. Signed-off-by:
-
Shawn Guo authored
Dynamically allocate duart devices for MX23 and MX28. Signed-off-by:
-
Shawn Guo authored
Create static memory mapping for MX23 and MX28. Signed-off-by:
-
Shawn Guo authored
Add clock for MXS-based SoCs, MX23 and MX28. Signed-off-by:
-
Shawn Guo authored
MXS-based SoCs implements iomux functions in block PINCTRL. Signed-off-by:
-
Shawn Guo authored
MXS-based SoCs implement gpio support in block PINCTRL. Signed-off-by:
-
Shawn Guo authored
There are 2 versions of the timrot on Freescale MXS-based SoCs. The v1 on MX23 only gets 16 bits counter, while v2 on MX28 extends the counter to 32 bits. The implementation uses two timers, one for clock_event and another for clocksource. MX28 uses timrot 0 and 1, while MX23 uses 0 and 2. Signed-off-by:
-
Shawn Guo authored
- DEBUG_LL support, which is incompatible with multi-soc MXS image because of different DUART base address on MX23 and MX28 - uncompress message support Signed-off-by:
-
Shawn Guo authored
Add Interrupt Collector (ICOLL) support for MXS-based. Signed-off-by:
-
Shawn Guo authored
- The mxs wdog is implemented in RTC block. - There is a generic software reset routine for most modules on mxs. Signed-off-by:
-
- 15 Dec, 2010 2 commits
-
-
Sascha Hauer authored
This iomux file has been constructed from the Freescale pinmux tool. It contains all pins from the tool, but the datasheet lists some configurations not present in the tool, these are not yet added. Signed-off-by: -
Lothar Waßmann authored
This patch actually replaces the 'struct pad_desc' with a u64 cookie to facilitate adding platform specific pad_ctrl settings to an existing pad definition. So, instead of: iomux_v3_cfg_t power_key = MX51_PAD_EIM_A27__GPIO_2_21; power_key.pad_ctrl = MX51_GPIO_PAD_CTRL_2; mxc_iomux_v3_setup_pad(&power_key); one can write: mxc_iomux_v3_setup_pad((MX51_PAD_EIM_A27__GPIO_2_21 & ~MUX_PAD_CTRL_MASK) | MX51_GPIO_PAD_CTRL_2); Patch applies to branch 'imx-for-2.6.38' of git://git.pengutronix.de/git/imx/linux-2.6Signed-Off-By:
Lothar Waßmann <LW@KARO-electronics.de> Signed-off-by:
-
- 14 Dec, 2010 7 commits
-
-
Fabio Estevam authored
Signed-off-by:
-
Arnaud Patard (Rtp) authored
When building as module: ERROR: "cpufreq_gov_performance" [arch/arm/plat-mxc/cpufreq.ko] undefined! WARNING: modpost: Found 1 section mismatch(es). To see full details build your kernel with: 'make CONFIG_DEBUG_SECTION_MISMATCH=y' make[1]: *** [__modpost] Error 1 make: *** [modules] Error 2 It's due to the driver using CPUFREQ_DEFAULT_GOVERNOR, even it should not (see commit 8122c6ce in Linus tree), so remove it. Signed-off-by:
Arnaud Patard <arnaud.patard@rtp-net.org> Signed-off-by:
-
Peter Horton authored
Add support for FIQ on mx51 TZIC TZIC changes tested with FIQ audio on an mx51 board AVIC changes build with mx3_defconfig, not tested Signed-off-by:
Peter Horton <phorton@bitbox.co.uk> Signed-off-by:
-
Fabio Estevam authored
Signed-off-by:
-
Fabio Estevam authored
Signed-off-by:
-
Peter Horton authored
Add SSI3 to MX51 Signed-off-by:
-
Fabio Estevam authored
Use clk_get to acquire the watchdog clock and also avoid hardcoding the clock name. Signed-off-by:
-
- 13 Dec, 2010 2 commits
-
-
Shawn Guo authored
Add helper definition and function for MXS-based. Signed-off-by:
-
Shawn Guo authored
Add core definitions for MXS-based SoC MX23 and MX28. Signed-off-by:
-
- 07 Dec, 2010 5 commits
-
-
Fabio Estevam authored
Signed-off-by:
-
Fabio Estevam authored
Signed-off-by:
-
Fabio Estevam authored
MX51 has two watchdog modules. Add support for both of them. Signed-off-by:
-
Linus Torvalds authored
Merge branch 'irq-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip * 'irq-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip: genirq: Fix incorrect proc spurious output
-
Linus Torvalds authored
Merge branch 'for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/mjg59/platform-drivers-x86 * 'for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/mjg59/platform-drivers-x86: wmi: use memcmp instead of strncmp to compare GUIDs ACPI, hp-wmi: Fix memory leak in acpi query msi-wmi: fix semantically incorrect use of keycode instead of scancode msi-wmi: Add mute key support asus-laptop: add wimax and wwan support eeepc-wmi: fix compiler warning ibm_rtl: _RTL_ is not available in UEFI mode ibm_rtl: Loosen the DMI criteria to all IBM machines drivers/platform/x86/thinkpad_acpi.c: delete double assignment eeepc-wmi: add cpufv sysfs documentation toshiba_acpi.c: Add key_entry for a lone FN keypress ibm_rtl: fix printk format warning
-
